Instruction/ maintenance manual of the product SP420 Dimplex
Go to page of 8
THESE INST RUCTIONS SHO ULD BE READ CAREFULLY AND RET AINED FOR FUT URE RE FERENCE. Dimensions (millimetres) Inst allation and Operating Instructions Electrical 08/18887/1 Issue 1 Fig.
8 566 240 600 1158 558 480 outline of wall fixing bracket wall plugs screws wall fixing bracket Inst allation Recommended Fixing Dimensions - Fig. 2 Fig. 3 Fig. 4 Fig. 5 Mark the bottom hole position (see Fig. 5), remove the heater ensuring that the bottom fixing bracket is rotated up.
Manual Operation The S tandby Switch (Switch 1) must be first turned ‘ON’ and the AUTO/MAN (Switch 2) switch set to ‘MANUAL ’ to operate the manual controls - see Fig 6. Note : When the fire is put in Manual mode the first time the flame effect will come on indicated by the Bottom neon coming on for 3 seconds - see Fig 7.
Remote Control Operation LCD display The LCD display shows the following functions: • Main menu points: OFF , FLAME, HEA T , TEMP , TIMER, PROG , and TIME . • Brightness of the flame effect shown as a bar chart in 4 steps (50 step s internally). • Remote control set temperature in °C (thermostat function).
Replacing the remote control The new remote control must be set up as follows: Press switch 1 to ON . Press switch 2 to AUTO (see Fig. 6). Press switch 3 to O for more than 3 seconds until both LED’s are on (see Fig. 7). Press the remote control’s enter button or the e f buttons.
The front surround will need to be removed in order to change lamps. W arning - The front surround is heavy and easily damaged !. The front surround is fixed with 4 spring loaded pins and is supported at the top by the chassis.
Cleaning W ARNING – AL W A YS DISCONNECT FROM THE POWER SUPPL Y BEFORE CLEANING THE HEA TER. For general cleaning use a soft clean duster – never use abrasive cleaners. The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners.
The product complies with the European Safety S tandards EN60335-2-30 and the European S tandard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336 Glen Dimplex UK Limited Millbrook House Grange Drive Hedge End Southampton Hampshire.
An important point after buying a device Dimplex SP420 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dimplex SP420 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dimplex SP420 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dimplex SP420 you will learn all the available features of the product, as well as information on its operation. The information that you get Dimplex SP420 will certainly help you make a decision on the purchase.
If you already are a holder of Dimplex SP420, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dimplex SP420.
However, one of the most important roles played by the user manual is to help in solving problems with Dimplex SP420. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dimplex SP420 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
