Instruction/ maintenance manual of the product DF3015 Dimplex
Go to page of 16
PRACTICAL USER’S GUIDE FOR THE DIMPLEX MULTIFIRE™ ELECTRIC FIREPLACE MODEL NUMBER: DF3015 Valued Customer, We are pleased that you have chosen to purchase an electric fireplace manufactured by Dimplex North America Ltd.Over the years, valuable memories will occur around the warmth and comfort of your hearth.
QUICK REFERENCE GUIDE FOR THE DIMPLEX ELECTRIC FIREPLACE 1. Prior to the first use of the fireplace verify the following: • Are the circuit breakers fo r the socket the unit uses on? • Are the light bulbs in your fire place loose? (to check, follow the instructions for replacing the li ght bulbs under the maintenance section of this manual) 2.
IMPORTANT INSTRUCTIONS SAVE THESE INSTRUCTIONS PLEASE RETAIN THIS USER’S GUIDE FOR FUTURE REFERENCE When using electrical appliances, basic precaut ions should always be followed to reduce the risk of fire, electric s hock, and injury to persons , including the following: 1.
Model Numbe r Serial Number Model Numbe r Serial Number IMPORTANT INSTRUCTIONS If you have any questions regarding our products please have the product model and serial numbers available upon call ing Dimplex customer service or te chnical support. To locate the model and serial number labels see below.
NOTE 1 A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, t he circuit breaker trips or fuse blows on a regular basis when the heater is operat ing.
FIREPLACE INSTALLATION 1. Install the fireplace assembly into the mant el. (refer to mantel assembly instructions) NOTE 1 A 15 AMP, 120 VOLT circuit is r equired.
CAUTION Clearance for air circulation beneath the fireplace insert is pr ovided by three rubber feet. DO NOT INSTALL THE FIREPLACE INSERT DIRECTLY ON CARPET OR SIMILAR SURFACES WHICH MAY RESTRICT AIR CIRCULATION. If inst alling the fireplace in a carpeted area, place a one-piece, solid, flat surfac e under the fireplace insert.
RESETTING THE TEMPER ATURE CUTOFF SWITCH Should the heater overheat, an automatic switch will turn the heater off and it will not come back on without being reset. The te mperature cutoff switch c an be reset by unplugging the unit, waiting 5 minutes and pl ugging the unit back in.
FREQUENCY INTERFERENCE If the fireplace does not respond properly to t he remote control, the remote operating frequency may have to be reset. The remote cont rol can send another frequency code to the circuit board to eliminate interference.
PURIFIRE ON/OFF BUTTON Press the “ Purifire™ On/Off ” button to tu rn the Purifire™ function ON . When the Purifire™ function is ON the Purifire™ symbol will flash. When off the symbol will be solid. The default setting for the Purifire™ is set at low speed.
PURIFIRE™ The Purifire™ includes a high efficiency f ilter to help improve the quality of air. 1. Press the butt on for the Purifire™ function. 2. Press the “ Purifire Low Speed ” button or the “ Purifire High Speed ” button to select LOW or HIGH.
To access the lower light bulb area: NOTE Figure 7 1. Slide fireplace out of mantel 2-3 inches. 2. Remove 4 Phillips scr ews from the right side of trim.
PURIFIRE™ FILTER The Purifire™ filter supplied in your fireplace is reusable and washable. The filter should be cleaned or replaced on average once a year. To clean the filter gently tap filter on a hard surface to dislodge any loose di rt or debris, and then clean with wa ter.
FIVE YEAR LIMITED WARRANTY Products to which this limited warranty applies This limited warranty applies to the following model of your ne wly purchased Dimplex electric fireplace DF3015 and to newly pur chas ed Dimplex firepl ace surrounds (mantels) and trims.
What this limited warranty does not cover This limited warranty does not apply to products that have been repaired (except by Dimplex or its authorized service representatives) or otherwise altered.
For surrounds (mantels) a nd trims for the period ending at midnight on the first anniversary of the date of first purchase, Dimplex will in its sole di scretion either repair or replace such defective su rrounds (mante ls) and trims or part thereof witho ut charge.
An important point after buying a device Dimplex DF3015 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dimplex DF3015 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dimplex DF3015 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dimplex DF3015 you will learn all the available features of the product, as well as information on its operation. The information that you get Dimplex DF3015 will certainly help you make a decision on the purchase.
If you already are a holder of Dimplex DF3015, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dimplex DF3015.
However, one of the most important roles played by the user manual is to help in solving problems with Dimplex DF3015. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dimplex DF3015 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
