Instruction/ maintenance manual of the product HRC200 Desa
Go to page of 36
For more information, visit www .desatech.com W ARNING: If the information in this manual is not .
www .desatech.com 1 13109-01G 2 SAFETY T ABLE OF CONTENTS Safety .................................................................. 2 Product Identication ........................................... 4 Local Codes....................................
www .desatech.com 1 13109-01G 3 .
www .desatech.com 1 13109-01G 4 SAFETY Continued system. The ODS shuts down the replace if enough fresh air is not available. See Air for Combustion and Ventilation, page 6.
www .desatech.com 1 13109-01G 5 LOCAL CODES Install and use replace with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code, ANSI Z223.1/NFP A 54 *. *Available from: American National Standards Institute, Inc.
www .desatech.com 1 13109-01G 6 W ARNING: This heater shall .
www .desatech.com 1 13109-01G 7 1. Determine the volume of the space (length x width x height). Length x Width x Height =__________cu. ft. (volume of space) Example: Space size 20 ft.
www .desatech.com 1 13109-01G 8 INST ALLA TION W ARNING: Never install the .
www .desatech.com 1 13109-01G 9 Figure 5 - Installing Hood to Firebox Note: Y our replace is designed to be used in zero clearance installations. Wall or framing ma - terial can be placed directly against any exterior surface on the rear , sides or top of your replace, except where standoff spacers are integrally at - tached.
www .desatech.com 1 13109-01G 10 INST ALLA TION Continued Figure 9 - Placing Hearth Base Accessory Against Wall Electrical Outlet Hearth Base Rigid Gas Line Gas Line Access Hole Figure 8 - Minimum Cle.
www .desatech.com 1 13109-01G 11 3. Install gas piping to replace location. This installation includes an approved exible gas line (if allowed by local codes) after the equipment shutoff valve. The exible gas line must be the last item installed on the gas piping.
www .desatech.com 1 13109-01G 12 INST ALLA TION Continued BUIL T -IN FIREPLACE INST ALLA TION Built-in installation of this replace involves installing replace into a framed-in enclosure.
www .desatech.com 1 13109-01G 13 INST ALLA TION Continued Mantel Clearances for Built-In Installation If placing mantel above built-in replace, you must meet minimum clearance between man - tel shelf and top of replace opening.
www .desatech.com 1 13109-01G 14 For propane/LP units, the installer must supply an external regulator . The external regulator will reduce incoming gas pressure. Y ou must reduce incoming gas pressure to between 1 1" and 14" of water . If you do not re - duce incoming gas pressur e, heater regulat or damage could occur .
www .desatech.com 1 13109-01G 15 INST ALLA TION Continued CONNECTING FIREPLACE TO GAS SUPPL Y Installation Items Needed • 5/16" hex socket wrench or nut-driver • Phillips screwdriver • sealant (resistant to propane/LP gas, not provided) 1. Remove replace screen.
www .desatech.com 1 13109-01G 16 INST ALLA TION Continued CAUTION: Make sure exter- .
www .desatech.com 1 13109-01G 17 INST ALLA TION Continued 5. Correct all leaks at once. 6. Light replace (see Operation , page 19. Check all other internal joints for leaks.
www .desatech.com 1 13109-01G 18 INST ALLA TION Continued Notches Figure 26 - Installing Fireplace Screen Screws for Mounting Screen OPTIONAL WIRELESS HAND-HELD REMOTE CONTROL ACCESSORIES 1.
www .desatech.com 1 13109-01G 19 INST ALLA TION Continued Remote Control Unit 1. Remove battery cover on back of remote control unit.
www .desatech.com 1 13109-01G 20 O F F P I L O T L O I H AU T O OFF ON O N Figure 32 - Control Knob and Ignitor Button Location (Shown as Supplied, No Control Options) Control Knob Ignitor Button Selector Switch Flame Adjustment Knob 4. Press in and turn control knob clockwise to the OFF position.
www .desatech.com 1 13109-01G 21 OPERA TION Continued MANUAL LIGHTING PROCEDURE 1. Follow steps 1 through 6 under Lighting Instructions , page 19. 2. Press control knob and light pilot wi th match. 3. Keep control knob pressed in for 30 sec - onds after lighting pilot.
www .desatech.com 1 13109-01G 22 OPERA TION Continued 1. Press the POWER and LOCK buttons together to turn on the hand-held remote control. 2. Press AUTO button to select this mode.
www .desatech.com 1 13109-01G 23 Figure 38 - Correct Pilot Flame Pattern (Natural Gas Pilot Shown) Figure 39 - Incorrect Pilot Flame Pattern (Natural Gas Pilot Shown) Pilot Burner Thermocouple Pilot Burner Thermocouple INSPECTING B URNER BURNER PRIMAR Y AIR HOLES Air is drawn into the burner through the holes in the tting at the burner entrance.
www .desatech.com 1 13109-01G 24 CLEANING AND MAINTENANCE .
www .desatech.com 1 13109-01G 25 TROUBLESHOO TING .
www .desatech.com 1 13109-01G 26 TROUBLESHOO TING Continued POSSIBLE CAUSE 1 . Control knob not fully pressed in 2. Control knob not pressed in long enough 3. Equi pme nt shuto ff valv e not fully open 4. P i lo t f l am e n o t t o uc h in g th er moc ou pl e, whi ch al lo ws thermocouple to cool, caus - in g pilo t ame to go out .
www .desatech.com 1 13109-01G 27 POSSIBLE CAUSE 1 . Not enough combustion/ ventilation air 1. T urni ng contro l knob to HI positio n when burne rs are cold 2. Air in gas line 3. Air passageways on heater blocked 4. Dirty or partially clogged burner orice(s) 1.
www .desatech.com 1 13109-01G 28 .
www .desatech.com 1 13109-01G 29 WIRING DIAGRAM Note: For proper operation of optional acces- sories, the wires from the switch to the control must be connected exactly as shown.
www .desatech.com 1 13109-01G 30 17 27 4 8 12 26 7 6 4 3 2 1a 1c 1b 5 9 28 14 13 25 15 16 21 1 1 10 19 20 19 23 22 18 24 29 P ARTS .
www .desatech.com 1 13109-01G 31 P ARTS This list contains replaceable parts used in your replace. When ordering parts, follow the instructions listed under Replacement Parts on page 29 of this manual.
www .desatech.com 1 13109-01G 32 P ARTS 4 11 14 8 14 9 3 14 9 9 2 1 6 7 10 14 12 5 1.
www .desatech.com 1 13109-01G 33 P ARTS This list contains replaceable parts used in your replace. When ordering parts, follow the instructions listed under Replacement Parts on page 29 of this manual.
www .desatech.com 1 13109-01G 34 NOTICE: All accessories may Purchase these replace accessories from your local dealer. If they can not supply these accessories, call DESA Heating, LLC at 1-866-672-6040 for information.
www .desatech.com 1 13109-01G 35 ACCESSORIES Continued W ALL-MOUNT ON/OFF SWITCH GWMS2 Allows the gas log heater to be turned on and off with a wall switch.
1 13109-01 Rev . G 09/08 NOT A UPC 113109 01 DESA Heating, LLC 2701 Industrial Drive Bowling Green, KY 42101 www .desatech.com 1-866-672-6040 WARRANTY KEEP THIS WARRANTY DESA HEA TING, LLC LIMITED WAR.
An important point after buying a device Desa HRC200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Desa HRC200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Desa HRC200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Desa HRC200 you will learn all the available features of the product, as well as information on its operation. The information that you get Desa HRC200 will certainly help you make a decision on the purchase.
If you already are a holder of Desa HRC200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Desa HRC200.
However, one of the most important roles played by the user manual is to help in solving problems with Desa HRC200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Desa HRC200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
