Instruction/ maintenance manual of the product E11J Dell
Go to page of 13
Dell Storage Center SC180 Expansion Enclosure Getting Started Guide Regulatory Model: E11J Regulatory Type: E11J001.
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
Before You Begin Consider the following best practices before setting up your SC180 expansion enclosure. • Before connecting any cables between the storage system and expansion enclosure, physically label each port and connector. • Always follow proper power-up and power-down procedures when cycling power across the network.
Installation and Configuration Before you begin the installation, make sure that the site where you plan to install the expansion enclosure has standard power from an independent source or a rack power distribution unit with a UPS. Safety Precautions Always follow these safety precautions to avoid injury and damage to Storage Center equipment.
Figure 1. SC180 Expansion Enclosure Components 1. Documentation 2. Hard Drives 3. Expansion enclosure 4. Rack rails WARNING: Two people using lift straps are required to lift the expansion enclosure to avoid injury. Installing the Expansion Enclosure in a Rack Install the SC180 expansion enclosure in a rack.
Figure 2. Mount the Expansion Enclosure Chassis in the Rack 1. SC180 expansion enclosure 2. Storage system 5. Secure the storage system chassis to the rack using hold-down brackets.
Figure 3. Installing DDIC in Drawer 1. DDIC 2. Bottom drawer CAUTION: If the DDIC fails to latch, do not use it and request a replacement from Dell Technical Support Services. If a faulty DDIC unlatches within a closed drawer, it can make the drawer unable to be opened.
Cabling the Expansion Enclosure to a Storage System Connect an SC180 expansion enclosure to the back-end SAS ports on an SCv2080 storage controller. NOTE: In an SC180 expansion enclosure, the left storage controller is storage controller 1 and the right storage controller is storage controller 2.
Figure 5. Power Cables 3. Secure each power cable to the expansion enclosure chassis using the strain relief fasteners. 4. Plug the other end of the power cables into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU).
NOM Information (Mexico Only) The following information is provided on the device described in this document in compliance with the requirements of the official Mexican standards (NOM): Importer: Dell Inc. de México, S.A. de C.V Paseo de la Reforma 2620-11 ° Piso Col.
Back-Panel Connectors (per EMM) • Supports Mini-SAS HD to Mini-SAS cable universally keyed. The following lengths are currently supported: SCv2080 to SC180: – 0.
Power Supplies Input frequency 50/60 Hz Max input power 1791 VA Input current 7.4 A@241 VAC Maximum inrush current Under typical line conditions and over the entire system ambient operating range, the.
Environmental Storage –40° to 70°C (–40° to 158°F) with a maximum temperature gradation of 20°C per hour Relative humidity Operating 20% to 80% (noncondensing) with a maximum humidity gradation of 10% per hour Storage 5% to 100% (noncondensing) Maximum vibration Operating 0.
An important point after buying a device Dell E11J (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dell E11J yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dell E11J - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dell E11J you will learn all the available features of the product, as well as information on its operation. The information that you get Dell E11J will certainly help you make a decision on the purchase.
If you already are a holder of Dell E11J, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dell E11J.
However, one of the most important roles played by the user manual is to help in solving problems with Dell E11J. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dell E11J along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
