Instruction/ maintenance manual of the product DVH640JU1 De Dietrich
Go to page of 47
13 EN CONTENTS 1 / SAFET Y INSTRUCTIONS • Important warnings __________________________________________ 1 4 2 / INST ALLING Y OUR DISHW ASHER • Dimensions f or building in appliances _____________.
14 EN 1/ SAFET Y INSTRUCTIONS • IMPORTANT WARNINGS Important: After unpacking your appliance, make sure that it has not suffered any damage during transport. Never connect up a damaged appliance. If your appliance is damaged, please contact your dealer.
15 2 / INST ALLING Y OUR DISHWASHER EN ? 547 642 à 730 maxi Fig. 1 • LIST OF PARTS SUPPLIED 3 L = 75 L = 40 Cups for front feet Self-adhesive anti-condensation plate Foam sound-proofing seal Sound-.
16 2 / INST ALLING Y OUR DISHWASHER EN • CONNECTING TO THE WATER SUPPLY A A B B Danger: The symbol indicates that the hose is fitted with an electrical device for cutting off the water supply (depending on the model). Do not leave this hose in water and do not cut it.
17 2 / INST ALLING Y OUR DISHWASHER EN 0.90m max 0.4m max 0.30m min 65°C max 1-10 bars 0 - 40 cm 30 cm mini Fig. 2 - 2 Fig. 2 - 1 Y ou can connect the end of the drain hose to: - A ventilated U-bend (Fig. 2-1) or - A sink U-bend (Fig. 2-1) When connecting to a U-bend, y ou must remove the flapper from the U-bend.
The appliance must be at a standstill when connecting to the electricity supply circuit. Before connecting y our appliance, ensure that: - The mains voltage indicated on the manufac- turer’s plate on y our machine matches the vol- tage supplied by y our installation.
19 2 / INST ALLING Y OUR DISHWASHER EN - + Fig. 4 Fig. 3.2 Fig. 3.1 Fig. 3.3 • INSERTION INTO THE NICHE • Glue on the anti-condensation plate (Fig. 3.1) • Glue on the foam sound-proofing seal (Fig. 3.1) • Clip the three cups under the feet to make the dishwasher easier to slide (Fig.
20 EN 2 / INST ALLING Y OUR DISHWASHER • FITTING THE DOOR PANEL (Cladding with a single panel) - Measure the distance between the floor and the bott om of the door panel on the adjacent unit (Dimension B , Fig.
21 2 / INST ALLING Y OUR DISHWASHER EN FITTING THE DOOR P ANEL (Cladding with 2 elements) - T o fit the first section, please refer to the pre- vious chapter “FITTING THE DOOR P ANEL (Cladding with a single panel) (Figs. 5. 1 et 5.2). - Position y our door panel by engaging the 2 screws in the holes in the dishwasher’ s door (Fig.
22 EN 2 / INST ALLING Y OUR DISHWASHER Warning: The screw provided is intended for a panel at least 16mm thick. If the panel is less than 16mm thick, change the screw or shor- ten it. Fig. 9 • SOUND-PROOFING SEALS T o improve the built-in appliance ’s sound- proofing, fit the sound-proofing seals (depen- ding on the model).
23 2 / INST ALLING Y OUR DISHWASHER EN B J P = Fig. 10.2 P P E Fig. 10.1 • REFITTING THE PLINTH Refit the plinth, cutting it away if necessary according to Dimension P (see table and Fig. 10. 1 ) Calculate dimension P (T able on last page): - T ake Dimension B from Fig.
EN INSTRUCTIONS FOR USE Dishwasher.
2 Dear Customer, You have just acquired a D D E E D D I I E E T T R R I I C C H H dishwasher and we would like to thank you. Our research teams have created this new generation of appliances for you. Their quali- ty, design, features and technological advances make them exceptional products, and reveal our unique know-how.
3 CONTENTS EN 1/ FOR THE USER’S A TTENTION • Safety instructions ______________________________________ 4 • Protection of the envir onment ______________________________ 5 • Economical, enviro.
4 EN 1/ FOR THE USER’S A TTENTION Important : Keep this user’s manual with your appliance. If the appliance is sold or trans- ferred to someone else, ensure that the man- ual is with it. Please take note of these instructions before installing and using your appliance.
5 EN 1/ FOR THE USER’S A TTENTION with a safety sys tem that immediately blocks the dishwasher’ s operation if the door is opened. — Never use chemical solvents in y our appliance because these could cause an explosion. — Alway s close your appliance’ s door af ter loading or remo ving your items.
6 EN 2/ DESCRIPTION OF Y OUR APPLIANCE Advice: This user’s guide is applicable to several models. There may be some slight differences in the details and the equipment between your appliance and the descriptions provided here.
7 EN 2/ DESCRIPTION OF Y OUR APPLIANCE • PRESENTATION OF THE CONTROL PANEL On/Off: Press this button t o star t y our dishwasher . Choosing a programme: briefly press one button or the o ther in succession to select y our programme.
8 EN 3/ INFORMA TION Important: To obtain impeccable washing and drying results from your dishwasher without any marks, you must set it carefully using the water softening system, which utilises rege- nerating salt. - Use the most suitable washing products f or the hardness of your t own’s wat er supply .
9 EN 4/ WHA T TO DO BEFORE FIRST USIN G THE MA CHINE In one simple action, you can test the y our water’ s lime content using the testing strip supplied with your dishwasher . Alternatively , contact your local water utility t o ascer tain y our water’s hardness.
10 EN 5/ DETERGENT PRODUCTS AND ADJUS TING THE W A TER SOFTENER Important: It is very important to set the water softener correctly. - If the setting is too low, there is the risk of chalky marks appearing. - if the setting is too high, there is the risk of causing clouding of the glasses.
11 EN 5/ DETERGENT PRODUCTS AND ADJUS TING THE W A TER SOFTENER NB: You can deactivate the “Salt” and “Rinsing” product lights if you are using multi-purpose products; this is done by using th.
12 EN 6/ LO ADING OF REGENERA TING SAL T • Loading of regenerating salt (Fig 06) Filling with salt is essential for pro viding a good wash without marks. It regenerates the resins that soften the water , by removing its lime content (unless the mains wat er supply is soft enough).
13 EN 7/ LO ADING OF RINSING PRODUCT Important : Only use a rinsing product designed for dishwashers. The rinsing product ensures your items shine and are well dried. When first putting the machine into ser vice, fill the tank until the lev el is flush with the top of the adjustment le ver .
14 EN 8/ Y OUR DISHWASHER’S EQUIPMENT Arrange your items so that the wat er can cir- culate freely and spray o ver all the utensils. Place large diameter dishes and pans at the sides. Do not int ersperse, jam together or superim- pose flat plates and concav e dishes (Fig.
15 EN 8/ Y OUR DISHWASHER’S EQUIPMENT Fig. 11 • THE UPPER BASKET This baske t is par ticularly designed to tak e glasses, cups, ramekins, small salad bowls, bowls and saucers. Arrange your items methodically t o save on space (arranging glasses, cups or bowls together).
16 EN 8/ Y OUR DISHWASHER’S EQUIPMENT Movable grills are available for if you wish to load your cutlery in an orderly manner (Fig. 1 3). For op timum washing and dr ying, use these separation grills par tially or t otally . Point the handles on the cutlery downwards.
17 EN 9/ SETTING THE PARAMETERS • SETTINGS POSSIBLE USING THE “SET” AND SELECTION BUTTONS: 1 long press • 1 long press on the “ S ET ” button and then a short press enables you to move on to the following parameters. Set the parameters by pressing one of the programme selection buttons or the other.
18 EN 10/ WASHING PR OGRAMMES • PROGRAMMES TABLE Air Dr ying Resistant V V e e r r y y d d i i r r t t y y A large amount of dried-on residue, baked-on stains, grease, residue from frying, cooked cheese, sauce, etc.
19 EN 10/ W ASHING PROGRAMMES Mixed Mixed Air Dr ying Hot rinse V V e e r r y y s s h h o o r r t t 3 3 0 0 - - m m i i n n u u t t e e wash specially designed for a small amount of daily items with a limited amount of non-greasy residue, not dried on.
20 EN 1 1/ PROGRAMMING Advice: Consult the Programmes table on the preceding pages to determine the programme you need for the type of items, the quantity and the amount of food residue. • Starting the appliance Press the “ O O n n / / Of f” butt on to switch the machine on.
21 EN 1 1/ PROGRAMMING • Delaying the end of a programme Programme the finishing time, in quar ter of an hour stages, by pressing the + or – butt ons until you reach the desired time. Confirm by pressing “Start” . The screen counts down hour by hour until the programme starts.
22 EN 12/ Y OUR DISHWASHER’S SAFET Y S YSTEMS • Door poorly closed If the door is poorly closed, the confirmed programme is automatically cancelled after 3 minutes.
23 EN 1 3/ CLEANING YOUR APPLIANCE Fig. 15 The filtration system consis ts of several elements: - - The waste filter - - The large main filter - - The micro filter The filters are located in the centre of the tub and must be washed regularly to obtain op ti- mum washing results.
24 EN 13/ CLEANING Y OUR APPLIANCE • Periodically Every 3 or 4 months, in order to remov e any deposits, run a special maintenance programme, with- out any items in the machine, using a special dishw asher cleaning product. Important : Keep this product out of children’s reach.
25 EN 14 / IF OPERA TING ABN ORMALITIES OCCUR • BEFORE CALLING FOR SERVICE Problem Possible C auses What to do? The door falls heavily when opened (integratable model) - Door springs not t ensioned enough to compensate f or the weight of the panel. - Tighten the two tensioning screws accessible in the bot- tom section abo ve the front feet.
26 EN 14 / IF OPERA TING ABN ORMALITIES OCCUR • RELATING TO PROGRAMMING, DISPLAY Problem Possible C auses What to do? The cycle lasts t oo long - The energy -sa ving program- mes last longer because.
27 EN 14 / IF OPERA TING ABN ORMALITIES OCCUR Problem Possible C auses What to do? Food traces and deposits in the glasses - Items poorly arranged (mas- ked b y another larger item or situated underneath it, items nested or jammed t ogether). - Upper spray arm blocked b y cutler y or a dish e tc.
28 EN 14 / IF OPERA TING ABN ORMALITIES OCCUR • POOR WASHING RESULTS... Problem Possible C auses What to do? White marks (identify what type) - Chalky film (removable with vinegar). - T races of salt (items have a salty taste). - Check that there is salt in the tank (light unlit = OK).
29 EN 14 / IF OPERA TING ABN ORMALITIES OCCUR Problem Possible C auses What to do? A lot of drople ts on the glasses - Lack or insuff icient amount of rinsing product. - The dose has not been distrib- uted. - Positioning of the items. - Check the indicator light and fill the tank completely .
30 EN EN 15/ AFTER -SALES SER VICE Fig. 16 • • INTERVENTION WORK Any intervention work on your appliance must be per f ormed by a qualified professional approv ed by the manufacturer . When you call, please mention the full reference for y our appliance (model, type and serial number).
31 EN • Details common to all models — Washing capacity - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 12 standard place settings — Ar rangement of the items - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Figs.
32 EN 15/ INDICA TIONS FOR THE TESTING L ABORA TORIES A 1 2 3 4 5 6 7 8 C B 71 1 1 1 1 1 2 2 2 2 2 33 2 33 3333 2 22 2 N N O O K K N N O O K K O O K K 8 8 8 8 8 8 3 3 3 3 4444 44 1 1 18 8 8 111 6 8 44.
33 EN NOTES.
34 EN NOTES.
35 EN NOTES.
36 Brandt Appliances - SAS au capital de 10.000.000 euros - R CS Nanterre 4 40 302 347 B3244-B-- 10/06 P P h h o o t t o o g g r r a a p p h h i i e e d d e e c c o o u u v v e e r r t t u u r r e e /.
An important point after buying a device De Dietrich DVH640JU1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought De Dietrich DVH640JU1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data De Dietrich DVH640JU1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, De Dietrich DVH640JU1 you will learn all the available features of the product, as well as information on its operation. The information that you get De Dietrich DVH640JU1 will certainly help you make a decision on the purchase.
If you already are a holder of De Dietrich DVH640JU1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime De Dietrich DVH640JU1.
However, one of the most important roles played by the user manual is to help in solving problems with De Dietrich DVH640JU1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device De Dietrich DVH640JU1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
