Instruction/ maintenance manual of the product CS-2000 Crimestopper Security Products
Go to page of 8
CS - 2000 REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a ™ Remote Alarm System by Crimestopper Security Products Inc. This booklet contains the information necessary for install ing, using, and maintaining your alarm system.
INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle man ufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES, AND BATTERY). TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle.
WIRING RED WIRE: +12V POWER INPUT (15 Amp fuse) Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the vehicle battery positive terminal. WHITE WIRE: + 12V FLASHING PARKING LIGHT OUTPUT (10 Amp Max.
WIRING YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS Connect to an ignition wire (or fuse in the fuse box) that shows +12 Volts when the key in both “On” and “Start” positions. BLACK WIRE: SYSTEM CHASSIS GROUND THIS WIRE MUST BE CONNECTED TO CHASSIS METAL OF THE VEHICLE.
PROGRAMMING SILENT ARMING /DISARMING The system can be silently armed and disarmed as normal with but with no siren chirp. Turn ignition on and press the #2 (Small) Button for about (3) seconds. You will hear (2) siren chirps. After the ignition is turned off, there will be no siren chirps on arm/disarm.
OPERATION REMOTE PANIC PROTECTION To sound the alarm upon command (panic), press and hold the #1 (Large) Button for at least (2) seconds until the siren sounds.
POWER DOOR LOCK WIRING + + +.
87A 86 87 30 85 87A 86 30 BATTERY + - IGN EMERGENCY DISARM/ VALET/ PROGRAM SWITCH PIN SWITCH (+)POSITIVE DOOR SW HOOD/TRUNK (-)NEGATIVE RELAY PIN SWITCH OPTIONAL STARTER KILL PIN SWITCH (-)NEGATIVE DOOR LED FUSE BOX + IGNITION "ON & START" START WIRE (-)DOOR TRIGGER YELLOW CUT (-) AUX.
An important point after buying a device Crimestopper Security Products CS-2000 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Crimestopper Security Products CS-2000 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Crimestopper Security Products CS-2000 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Crimestopper Security Products CS-2000 you will learn all the available features of the product, as well as information on its operation. The information that you get Crimestopper Security Products CS-2000 will certainly help you make a decision on the purchase.
If you already are a holder of Crimestopper Security Products CS-2000, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Crimestopper Security Products CS-2000.
However, one of the most important roles played by the user manual is to help in solving problems with Crimestopper Security Products CS-2000. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Crimestopper Security Products CS-2000 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
