Instruction/ maintenance manual of the product CS-2011RS CrimeStopper
Go to page of 16
CS-2011RS Series IV Super Rage™ Remote Control Alarm & Remote Engine Starting System OPERATION INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a Super Rage ™ Alarm & Remote Engine Starter by Crimestopper Security Products Inc. This booklet contains the information necessary for operating your system.
TABLE OF CONTENTS Operation Cautions & Warnings……..………..…………………………………………………………….………2 Operating Instructions - Alarm……………………………………………………….……….
OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press and release button #1 (Lock sym bol) on the transmitter. The System will arm and confirm with one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped).
OPERATING INSTRUCTIONS - ALARM Prior intrusion Alert This system will notify you if the alarm was tripped wh ile you where away. Upon di sarming, the two normal disarm chirps will be heard then the system will emit 4 additional siren chirps. Check your vehicle for any signs of a break in or tampering.
OPERATING INSTRUCTIONS - ALARM Remote AUX. Output 2 (Optional) This system contains a second auxiliary output to acti vate other accessories or devices. To activate the systems’ Second Auxiliary Output, press and hold Button #3 (Trunk Symbol) on the transmitter for more than 2 seconds.
OPERATING INSTRUCTIONS - ALARM Optional M.A.P. (Mobile Accessories Protection) This system can be programmed to provide Crimestopper’ s unique M.A.P. (Mobile Accessories Protection) feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or Entertainment systems.
REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM: A FTER IGN 3 ST ARTER THEN FLA SH 1X SOLID SOLID SEC. ST AR T REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the firs t attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2 nd and 3 rd time.
REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock/Disarm system (If armed) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park.
REMOTE ENGINE CONTROL INFINITY RUN MODE This mode allows the vehicle’s engine to remain running INDEFINITELY. This mode can be beneficial to law enforcement vehicles or commercial vehicles that need to remain running unattended for long periods of time.
REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA.
OPTIONAL TURBO TIMER MODE OPTIONAL TURBO TIMER MODE: IMPORTANT NOTE: This mode requires the use of an extra part called a momentary switch or button that is not included with the kit.
ANTI CARJACK PROTECTION REMOTE OPERATED CARJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button for 2 seconds.
TRANSMITTER PROGRAMMING Note: Remotes Transmitters come pre-programmed fr om the Factory. When re-learning remotes or adding remotes, ALL your system’s remote codes mu st be learned at time of programming!! This system allow storage of up to 4 different remote codes in memory.
2 VEHICLE OPERATION The CS-2011RS Series IV system can be used for 2 car operation. A single remote can control two independent vehicles with an identical systems installed.
TROUBLESHOOTING: “BEFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following section for tips that may remedy or explain your problem. SYSTEM LED FLICKERS WHEN PRESSING REMOTE CONTROL BUTTONS: This is normal operation.
ONLINE TECHNICAL SUPPORT www.crimestopper.com/techweb03.html www.crimestopper.com email@crimestopper.com Phone (800) 998-6880 FAX (805) 581-9500 © 2003 Crimestopper Security Products.
An important point after buying a device CrimeStopper CS-2011RS (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought CrimeStopper CS-2011RS yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data CrimeStopper CS-2011RS - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, CrimeStopper CS-2011RS you will learn all the available features of the product, as well as information on its operation. The information that you get CrimeStopper CS-2011RS will certainly help you make a decision on the purchase.
If you already are a holder of CrimeStopper CS-2011RS, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime CrimeStopper CS-2011RS.
However, one of the most important roles played by the user manual is to help in solving problems with CrimeStopper CS-2011RS. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device CrimeStopper CS-2011RS along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
