Instruction/ maintenance manual of the product CD53 Creek Audio
Go to page of 16
Creek CD53 & CD50 C C o o m m p p a a c c t t D D i i s s c c P P l l a a y y e e r r s s Ope rat ing Inst ruct ions.
2 CD 53 & CD50 Compact Disc Player This CD player is designed to operate on 220-240 Volts 50Hz AC or 110-120 Volts 60 Hz AC. Normally the equipment is supplied with a mains lead with a fitted 3 pin plug suitable for the country it is to be used in.
3 CD 53 & CD50 Compact Disc Player N N O O T T E E The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations.
4 CD 53 & CD50 Compact Disc Player C C A A U U T T I I O O N N Before connecting or disconnecting a unit from your audio system, make sure that you switch off the power to each component. Ensure that you make the correct connections, paying attention to the L (left channel) and R (right channel) marks.
5 CD 53 & CD50 Compact Disc Player M M A A I I N N U U N N I I T T 1. STANDBY button 2. Disc Tray 3. OPEN/CLOSE button 4. STOP button 5. PAUSE button 6. PLAY button 7. SKIP BACK button 8. SKIP FORWARD button 9. SCAN BACK button 10. SCAN FORWARD button 11.
6 CD 53 & CD50 Compact Disc Player EXPLANATI ON OF CONTROL S REMOTE CONTROL UNIT A. S T ANDBY B. NUMERICAL track selection C. PROGRAM D. REPEA T A ↔ ↔ B E. REMAINING TIME F . REPEA T G . SKIP TRACK back & forward H. SEARCH back & forward I.
7 CD 53 & CD50 Compact Disc Player COMPAC T DISCS HANDLING THE DISCS This unit has been designed to play Compact Discs bearing the identification logo shown below. DVD discs cannot be played. Always place the CD in the disc tray with the label facing up.
REMOVING THE DISC The disc tray can be opened at any time by pressing the OPEN/CLOSE button. Remove the disc only after the tray has fully opened. CAUTION Do not put anything except a Compact Disc into the tray. Foreign objects can damage the mechanism.
7. At the end of the last track the CD will return to a waiting mode. NOTE S: If the CD is deeply scratched, too dirty, or not recorded to Sony/Philips ‘Red Book’ standards, the disc may not play. If an improperly centered disc is played, noise will be heard in the mechanism.
TO ‘PAUSE ’ THE DISC PLAY Press the PAUSE button. The disc will stop playing at the current play position and PAUSE will be displayed. Press the PAUSE button again or press PLAY to resume disc play.
‘ SKIP BACK’ TO THE PREVIOUS TRACK To skip to the beginning of track 3, for example, while track 4 is playing, follow the steps below: Press the button on the front panel, or the button on the remote handset twice. The player will skip to the beginning of the current track.
P P R R O O G G R R A A M M M M E E D D D D I I S S C C P P L L A A Y Y (Remote control only) This feature allows you to play tracks in your preferred sequence. It is not possible to program the CD player while the disc is playing. So, press the STOP button first, then enter a program.
R R E E P P E E A A T T D D I I S S C C P P L L A A Y Y Use the REPEAT button to repeat a track, all tracks on the disc, or a programmed sequence of tracks. ‘REPEAT’ ONE TRACK Make sure that the PROGRAM function has not been selected. 1. Press the REPEAT button once and the REPEAT 1 message will appear.
3 . To clear REPEAT , press the button or the REPEAT button once. I I N N T T R R O O / / S S C C A A N N M M O O D D E E (Remote control only) The INTRO/SCAN feature allows you to listen to the first ten seconds of each track in turn so you can evaluate a disc or choose your preferred track.
TROUBL ESHOOTI NG GU ID E If you have followed the instructions, and are having difficulty operating your compact disc player, please use the simple guide below to help you solve the problem. Here we have listed the most common hiccups experienced by the users, which we hope will be of some help.
12 Avebury Court, Mark Road, Hemel Hempstead, Herts, HP2 7T A England. Tel: + 44 (0)1442 260146 Fax: + 44 (0)1442 243766 E-mail: info@creekaudio.co.uk Internet: www.creekaudio.co.uk Creek Audio Limited reserves the rights to modify or change the specification of its products without notice.
An important point after buying a device Creek Audio CD53 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Creek Audio CD53 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Creek Audio CD53 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Creek Audio CD53 you will learn all the available features of the product, as well as information on its operation. The information that you get Creek Audio CD53 will certainly help you make a decision on the purchase.
If you already are a holder of Creek Audio CD53, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Creek Audio CD53.
However, one of the most important roles played by the user manual is to help in solving problems with Creek Audio CD53. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Creek Audio CD53 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
