Instruction/ maintenance manual of the product GLX50 Crate Amplifiers
Go to page of 8
User ’ s Guide GLX50 Dual Input Guitar Amplifier with Digital Signal Processing.
T ABLE OF CONTENTS: Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 The Digital Signal Processor . . . . . . . . . . . . . . . . . . . . .3 The Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4,5 Suggested Settings .
The Digital Signal Processor: Crate’s Digital Signal Processing of fers eight exciting digital effects, accessible through the DSP Mode control. The effects are described below . Use the Mode control to select the effect and the Level control to mix in the desired amount of each effect.
The Front Panel: 4 1 3 5 6 7 8 9 10 4 2 NOTE: Channel A and Channel B are independent of each other up to the DSP and CD inputs. The text below (#1–10) applies to both channels. 1. INPUT : Use this 1/4” jack to connect your guitar to the amplifier by means of a shielded instru- ment cable.
5 11 12 13 14 18 15 17 16 1 1. DSP MODE: Use this control to select one of the eight built-in digital effects. A listing of the effects is printed below the control knob.
Suggested Settings: 6 CRYSTAL CLEAN: OUT PUNCHY CLEAN: OUT DIRTY PUNCH: IN DIRTY BLUES: IN EDGIE: IN SWEATY METAL: IN ARENA METAL: IN MAMMOTH METAL: IN GLX50 Guitar Amplifier with Digital Signal Proce.
System Block Diagram: 7 INPUT OVER- DRIVE CLEAN OD GAIN LEVEL POWER AMP SPEAKER CD INPUTS HIGH MID LOW EFFECTS OD LEVEL OD GAIN OD LEVEL LEVEL LEVEL MODE DSP MIX STAGE HEAD PHONES CHANNEL A: INPUT OVE.
GLX50 TECHNICAL SPECIFICA TIONS: Output Power Rating 50 watts RMS @5% THD, 4 ohm load Maximum Input Signal Accepted 5 volts peak-to-peak T otal System Gain Clean Channel 70dB, all controls @10 Overdrive Channel 1 10dB, all controls @10 Input Impedance 270k ohm T one Controls Low 28dB range @ 40Hz Mid 20dB range @ 1.
An important point after buying a device Crate Amplifiers GLX50 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Crate Amplifiers GLX50 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Crate Amplifiers GLX50 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Crate Amplifiers GLX50 you will learn all the available features of the product, as well as information on its operation. The information that you get Crate Amplifiers GLX50 will certainly help you make a decision on the purchase.
If you already are a holder of Crate Amplifiers GLX50, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Crate Amplifiers GLX50.
However, one of the most important roles played by the user manual is to help in solving problems with Crate Amplifiers GLX50. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Crate Amplifiers GLX50 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
