Instruction/ maintenance manual of the product 919.176830 Craftsman
Go to page of 18
S_FA/RS OWNERS MANUAL MODEL NO. 919.17673g 919.17683 aMPORTANT: Read the Safety Guidelines and AH instructions Carefully Before Operating CRAFTSMAN AiR COMPRESSOR ASSEMBLY OPERATION MAINTENANCE REPAIR PARTS Record in the spaces provided. (1) The model number which can be found on the tabel on the rear of the air tank.
TABLE OF CONTENTS Page .................................................................. 3 SAFETY GU_DEUNES ........................................................ 3 WARNING CHART ............................................................. 3 SPECIFICATION CHART .
FULL ONE YEAR WARRANTY ON COMPRESSORS if this air compressor fans due to a defect in material or workmanship within one year from the date of purchase, return it to the nearest Sears Service Center/Department throughout the United States and Sears wiii repair it, free of charge.
WHAT TO LOOK FOR WHAT COULD HAPPEN NOW TO PREVENT }T Hot Parts The compressor head and tubes get hot when Never touch the air compressor head or tubes dar- the air compressor is running. If you touch them, ing or immediately after operation. you can be seriously burned.
SPEC_FICATION CHART Modem No. 919.176730 9t&176830 Horsepower 3 3 Displacement CFM 11.3 11.3 Bore 2%" 2%" Stroke 2" 2" Voltage-Single Phase !20/240"* 120/240"* Minimu.
ACCESSORIES FOR USE WiTH SEARS COMPRESSORS The following accessories are available through the current general sales catalog or at fuliqJne Sears stores. ,SPRAY GUNS °BLOW GUNS oAIR CAULKING GUNS oAIR POWERED WASHER GUNS ,SAND BLASTERS °AIR BRUSHES oAIR LINE FILTERS oTIRE AIR CHUCKS .
Pressure Switch: The pressure switch automatically starts the motor when the sir tank pressure drops below the factory set"cat-in" pressure, it stops the motor when the air tank pressure reaches the factory set "cut-out" pressure. Regumstor: The air pressure coming from the air tank is controlled by the regulator knob.
GUARD t Jt may be necessary to brace or support one end of the outfit when attaching the wheels because the air compressor will have a tendency to tip. mnstagJiag Rubber Foot Strip and Wheels t. Remove the protective paper strip from the adhesive- backed rubber foot strip.
Grounding _nstructions iMPROPER GROUNDING CAN RESULT tN ELECTRICAL SHOCK= IN THE EVENT OF A SHORT CIRCUIT, GROUNDING REDUCES THE RiSK OF SHOCK BY PROViDiNG AN ESCAPE WiRE FOR THE ELECTRIC CUR- RENT, THIS A_R COMPRESSOR MUST BE PROPERLY GROUNDED.
NOTE W'_TER WILL CONDENSE IN THE A_R TANK. mF NOT DRAtNED_ WATER W_LL CORRODE AND WEAKEN THE AR TANK; CAUSING A R_SK OF AIR TANK RUPTUREo 1!. With tank pressure at approximately 20 psi., open the drain cock (key 43, pg. 14) and atlow moisture to drain.
NOTE If the overload protector shuts the motor offfre- quently, check for a possible voltage problem Low voltage can alsobe suspected when: 1. the motor does not get up to fulI power or speed; 2. fuses blow out when the motor is started. 3. lights dim when motor is started, and remain dim while it is running.
TROUBLESHOOTING GUIDE (continued) PROBLEM CAUSE CORRECTION Air leaks at check valve Defective or dirty check valve. A defective check valve results in a constant air teak at the pressure reiease valve when there is pressure in the tank and the compressor is shut off.
PROBLEM Excessive belt wear (continued) CORRECTION Adjust tension. See Belt Replacement, pg, 11. Adjust tension. See Belt Replacement, pg. 11. Check for worn keyway or pulley bore. Also check for bent motor shaft. Replace parts if necessary. TROUBLESHOOTING GUIDE CAUSE Loose belt, Tight belt.
AIR COMPRESSOR DtAGRAM (view from back} 54 53 52 5O 48 2 55 "58 !8 34 I7 14 12 "43 51A _J 35 (Model No. shown here) 42 4! (See pg. 8, Step 2 for proper wheel placement and assembly) 14.
COMPRESSOR PUMP D_AGRAM 89 82 83 (od "Ill p ugl / / / _o_, dra,n plug} _5.
r PARTS LiST KEY NO PART NUMBER f CAC=322 2 CAC_323 3 SSF-8113-ZN 4 CAC-327 5 CACo4OG3-1 6 9=16279 7 265-18 8 SSF-935 9 LA-1779 10 STD575051 11 STD575050 12 CAC-317 13 TIA-4325 TIA-4125 14 C-GA-345 15.
55 C-BT-222 56 SSN°1619oZN 57 SSN=56=ZN 58 CAC-1011 59 SSFo6627 60 CAC-293 61 SSF-955 62 SS=8553 ($3 SSP=940t _/ 84 CAC=291 O 65 265-25 66 SSF-9821 67 CACo294 68 265=196 69 CA0-289 70 CAC-54_1 71 CAC.
OWNERS MANUAL SERVICE MODEL NO. 919.176730 919.176830 HOW TO ORDER REPAIR PARTS CRAFTSMAN AIR COMPRESSOR Now that you have purchased your Sears Air Compressor, should a need ever exist for repair parts or service, simply contact any Sears Service Center and most Sears, Roebuck and Co.
An important point after buying a device Craftsman 919.176830 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Craftsman 919.176830 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Craftsman 919.176830 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Craftsman 919.176830 you will learn all the available features of the product, as well as information on its operation. The information that you get Craftsman 919.176830 will certainly help you make a decision on the purchase.
If you already are a holder of Craftsman 919.176830, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Craftsman 919.176830.
However, one of the most important roles played by the user manual is to help in solving problems with Craftsman 919.176830. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Craftsman 919.176830 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
