Instruction/ maintenance manual of the product 358.745511 Craftsman
Go to page of 12
Instruction Manual 25cc/1.5 cu.in. 2-Cycle 17 Inch Cutting Path / 0.080 In. Line GASOLINE WEEDWACKER ® Model No. 358.745511 • Safety • Assembly • Operation • Maintenance • Parts List • Espa_ol For Occasional Use Only _YL_) WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product.
Warranty Statement 2 Storage 10 Safety Rules 2 Troubleshooting Chart 11 Assembly 4 Emissions Statement 11 Operation 5 Parts List 13 Maintenance 8 Spanish 15 Service & Adjustments 9 Parts and Ordering BackCover FULL ONE YEAI_.
If situations occur which are not cov- ered in this manual, use care and good judgment. If you need assis- tance, contact your Sears Service Center or call 1-800-235-5878. OPERATOR SAFETY • Dress properly. Always wear safety glasses or similar eye protection when operating, or performing main- tenance, on your unit (safety glasses are available).
• Store unit and fuel in area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, fur- naces, etc. • Store unit so line limiter blade can- not accidentally cause injury. The unit can be hung by the tube.
KNOW YOUR TRIMMER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. Never use engine or carburetor clean- er products in the fuel tank or perma- nent damage may occur.
OPERATING INSTRUCTIONS It is recommended that the engine not be operated for longer than 1 minute at full throttle. OPERATING POSITION ALWAYS WEAR: l_y "e Long Pants Protection Heavy Shoes To advance line: • Operate the engine at full throttle.
also can cut the tender bark of trees or shrubs and scar fences. To help avoid damage especially to delicate vegetation or trees with tender bark, shorten line to 4 - 5 inches (10 - 13 cm) and use at less than full throttle.
CHECK FOR DAMAGED OR WORN PARTS Contact Sears Service Center for re- placement of damaged or worn parts. • ON/STOP Switch - Ensure ON/STOP switch functions properly by pushing and releasing the switch. Make sure engine stops. Wait 5 seconds be- fore attempting to restart unit to al- low switch to reset.
8, Push the line into the notch, leaving 3 to5 inches ( 7 - 12 cm) unwound. 9, Insert the line into the exit hole in the hub as shown in the illustration, 10, _ig.,n the notch with the line exit 11, Push spool into hub until it snaps into place. 12, Pull the line extending outside ofthe hub torelease itfrom the notch.
OTHER ° Do not store gasoline from one sea- son to another. * Replace your gasoline can if it starts to rust. TROUBLESHOOTING TABLE _ WARNING: Always stop unit and discennect spark plug before perform- mg all of the recommended remedies below except remedies that require operation of the unit.
ER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control War- ranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by Sears.
An important point after buying a device Craftsman 358.745511 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Craftsman 358.745511 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Craftsman 358.745511 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Craftsman 358.745511 you will learn all the available features of the product, as well as information on its operation. The information that you get Craftsman 358.745511 will certainly help you make a decision on the purchase.
If you already are a holder of Craftsman 358.745511, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Craftsman 358.745511.
However, one of the most important roles played by the user manual is to help in solving problems with Craftsman 358.745511. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Craftsman 358.745511 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
