Instruction/ maintenance manual of the product 18 WX ST Cobra Electronics
Go to page of 9
Installation Location Plan the location of the transceiver and microphone bracket before starting the installation. Select a location that is conve- nient for operation and does not interfere with the driver or passengers in the vehicle.
Mobile whip antennas utilize the metal body of the vehicle as a gr ound plane. When mounted at a corner of the vehicle they ar e slightly dir ectional, in the direction of the body of the vehi- cle. For all practical purposes, however , the radiation pattern is non-dir ectional.
T emporary Mobile Operation T o operate your COBRA transceiver from a car on a tempo- rary basis, you may want to purchase an additional ciga- rette lighter adapter fr om your COBRA dealer . This adapter and a magnetic mount antenna allow you to quickly "install" your transceiver for temporary use.
B. Rear Panel 1. Antenna Connector . This female connector permits connection of the transmission line cable male connec- tor to the transceiver . 2. External Speaker . The External Speaker Jack is used for remote r eceiver monitoring. The external speaker should have 8-ohm impedance and be rated to handle at least 4.
SOUNDTRACKER SYSTEM While previous systems only Òblanked outÓ or limited noise in higher sound frequencies, the r evolutionary new SoundT racker System actually reduces noise while leaving the signal intact in the reception mode.
A Few Rules That Should Be Obeyed 1. Y ou are not allowed to carry on a conversation with anoth- er station for more than five minutes at a time without tak- ing a one-minute break to give others a chance to use the channel.
7 If Y ou Think Y ou Need Service, Call 773-889-3087 “If your product should require factory service please call Cobra first before sending your unit in. This will ensure the fastest turnaround time on your repair .” Y ou may be asked to send your unit to the Cobra factory .
ELECTRET CONDENSER MICROPHONE Replacement microphone with 4-pin screw-on connection 545-157-N-004 $15.00 DC POWER CORD Exact replacement 420-002-N-001 $7.00 MOUNTING BRACKET Exact replacement 250-003-N-001 $4.50 MOUNTING BRACKET SCREWS Exact replacements 523-775-9-001 $.
FOLD HERE T APE TOP FLAP OVER THIS PRINTING 6500 W est Cortland Street Chicago, IL 60707 PLACE ST AMP HERE Printed in Thailand ©Cobra Electronics Corporation 1997 480-183-P-001 18.
An important point after buying a device Cobra Electronics 18 WX ST (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Cobra Electronics 18 WX ST yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Cobra Electronics 18 WX ST - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Cobra Electronics 18 WX ST you will learn all the available features of the product, as well as information on its operation. The information that you get Cobra Electronics 18 WX ST will certainly help you make a decision on the purchase.
If you already are a holder of Cobra Electronics 18 WX ST, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Cobra Electronics 18 WX ST.
However, one of the most important roles played by the user manual is to help in solving problems with Cobra Electronics 18 WX ST. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Cobra Electronics 18 WX ST along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
