Instruction/ maintenance manual of the product CYBER 2 Clifford
Go to page of 9
.
Stan dard Fea tures The fol low ing are stan dard fea tures of this sys tem. Some ve hi cles may re quire op tional pa r ts/wir ing and a few are in com pati ble with some fea tures. Main te nanc e Your Clifford system requires no maintenance except for periodic replacement of the remote control batteries.
Wel come to the world of high- technology ve hi cle se cu rity and con ven ience C ongratulations on the purchase of your Clifford Electronics mobile security/convenience system. Clifford Electronics has long been recognized as th e leading manufacturer of high-technology vehicle security systems.
Add ing new re mote con trols For other drivers, or to control Clifford G4 systems on your other cars with the same remote, you can buy additional remote controls from any Cliffor d Dealer (or direct from the Customer Service Department of your nearest Clifford Headquarters liste d on the front cover) and program them into the system yourself.
User- Selectable AutoLock and Aut oUn Lock ™ Some vehicles are incompatible with the AutoLock and AutoUnLock features. For your safety and that of your passengers, the doors automatically lock the instant you turn on t he ignition. When you turn the ignition off, AutoUnLock automatically unlocks the doors.
Smart trunk re lease op tion If you have this option, you may use the button to remotely release the trunk latch. The system’s electronic interlock prevents unintentional activation of the remote trunk release when you drive, or when the system is armed.
Smart prior in tru sion at tempt aler t If you hear three chirps when you disarm, it means that a trigger or sensor was activated in your absence. When you turn on the ignition, the LED will flash 1-8 times, pause, then repeat the flash cycle 4 more times.
a. To select another feature in that same column, repeat step 5 within the next 5 seconds (after 5 seconds, 3 chirps mean you are back to the “Feature Select” position). b. To select a different feature column, go to step 4. c . To exit program mode, turn the ignition off (you’ll hear 3 chirps and the LED will turn off).
Re set All Fea tures If you wish to reset all the user-selectable features to their normal factory presets, you can do s o simply by choosing the Reset all features selection (column 1, row 7) on the Table of User-Selectable Features .
An important point after buying a device Clifford CYBER 2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Clifford CYBER 2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Clifford CYBER 2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Clifford CYBER 2 you will learn all the available features of the product, as well as information on its operation. The information that you get Clifford CYBER 2 will certainly help you make a decision on the purchase.
If you already are a holder of Clifford CYBER 2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Clifford CYBER 2.
However, one of the most important roles played by the user manual is to help in solving problems with Clifford CYBER 2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Clifford CYBER 2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
