Instruction/ maintenance manual of the product TVS5091 Clarion
Go to page of 12
5” LC D Color T V OWNER’S MANUAL T VS5091.
INTRODUCTION The Clarion TVS5091 is a full-featured 5" LCD Color TV. It can be used as a stand-alone unit or integrated into a mobile multimedia system. ABOUT THE MANUAL AND W ARRANTY T o start enjoying your new Clarion TVS5091, please read the instructions listed in this manual.
• Do not disassemble or modify the set. Doing so may damage it and voids your warranty . • . Keep drinks and drops from umbrellas away from the set. W ater may damage the internal circuitry • Do not let lit cigarettes or other hot objects touch the set.
BUTTON LOCA TIONS 4 1 Power ON/OFF Switch 2 DC Power Connector 3 Diversity Input (Future Use) 4 Internal Speaker 5 FM T ransmit Switch 6 IR Remote Sensor 7 Stand-By Indicator 8 Rod Antenna 9 Power But.
CAR ST AND INSTALLA TION 1. Choose the proper place to install. Make sure the surface is dry and clean. • If mounting on a flat surface, use a screwdriver to remove the two screws on the bottom of the stand to take away the support bracket. • If mounting on an angled surface, bend the support bracket to fit the curve of the install surface.
REMOTE CONTROL BA TTER Y INST ALLA TION • Insert 2 AAA batteries into the compartment located on the back of the unit, following the polarities as shown. NOTES: • Each time you change the batteries, you must reprogram the unit. • W e suggest you use alkaline batteries; do not use rechargeable batteries.
5. If the rod antenna is used, adjust the antenna direction to get the best reception. If unit is used in a vehicle, the Clarion ZCB301 Auxilliary TV Antenna is recommended to improve the reception. 6. Adjust the viewing angle. The recommended viewing angle of the TV unit is – 30 to +10 degrees vertical and +45 to –45 degrees horizontal.
AUDIO ADJUSTMENT 1. Press the V olume Up and Down buttons on the unit or remote control to adjust the volume output level. 2. T o mute the unit, press the Mute button on the remote control.
Problem: No picture or sound on unit. Solution: • TV/AV1/AV2 mode may be selected incorrectly – Press the Input Selection button to the correct mode. • The TV and AV sources may be incorrectly connected – Check the connection and correct it. Problem: The picture is blurry and noisy .
Problem: Sound is poor with FM transmission (the TV sound through car audio system). Solution: • Make sure the FM transmitter is switched to setting 1 or 2 and the correct station for FM transmitter is set. (88.7 for setting 1 or 89.1 for setting 2) • The monitor may be too far away from the radio antenna.
NOTES 11.
661 W. Redondo Beach Blvd. Gardena, CA 90247 1-800-GO-CLARION www.clarion-usa.com TVS5091-10 Rev .2 (03/00).
An important point after buying a device Clarion TVS5091 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Clarion TVS5091 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Clarion TVS5091 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Clarion TVS5091 you will learn all the available features of the product, as well as information on its operation. The information that you get Clarion TVS5091 will certainly help you make a decision on the purchase.
If you already are a holder of Clarion TVS5091, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Clarion TVS5091.
However, one of the most important roles played by the user manual is to help in solving problems with Clarion TVS5091. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Clarion TVS5091 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
