Instruction/ maintenance manual of the product MS2004 Clarion
Go to page of 20
.
C ongratulations on your purchase of this Ungo System. Please read this manual thoroughly to familiarize yourself with your system’s components and operation. Discuss any questions you might have with your installing dealer. Record the serial number of your Ungo system and keep all dealer records and receipts.
Table of Contents 1. About Your Ungo Security System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 1 2. Remote Transmitters Remote Transmitter Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
Ungo Security Systems are state-of-the-art vehicle protection systems equipped with features designed to: p Deter potential intrusions to the vehicle by continually flashing the system LED status indicator while the system is Armed, giving a visual indication to any passer-by that the vehicle is equipped with a security system.
Page 2 - MS2004 Owner’s Manual Remote Transmitter Layout The Ungo MS2004 comes with 2 multi-function Remote Transmitters used to control nearly all of the system’s features. Each time a transmitter button is pressed, the LED will flash to indicate that a transmission is taking place.
MS2004 Owner’s Manual - Page 3 Battery Replacement Your Ungo Remote Transmitter uses a 12 volt alkaline battery, which will need to be replaced from time to time. Under normal conditions, the battery may last for up to a year before it needs replacement.
Page 4 - MS2004 Owner’s Manual Remote Arming When Armed, the system monitors and protects 4 independent areas, or zones , including the doors, hood/trunk, shock sensor and optional sensor. To Arm the System: 1. Turn off the ignition. 2. Press Button 1.
MS2004 Owner’s Manual - Page 5 To Bypass the sensors: 1. After arming the system, press Button 1 again on the Remote Transmitter within 5 seconds. • The siren will chirp 5 times, indicating the sensors have been bypassed. 2. The sensors will remain bypassed until the next time the system is armed.
Page 6 - MS2004 Owner’s Manual Arming Mode Selection Your system can be set in one of the following Arming Modes: • Passive (automatic) Arming with chirp confirmation • Active Arming (by Remote Only) • Passive (automatic) Arming without chirp confirmation To set the Arming Mode: 1.
MS2004 Owner’s Manual - Page 7 To enter Panic Mode: 1. Press and hold Button 1 for 3 seconds. • The siren will sound. • The doors will unlock. 2. Press Button 1 again to stop panic and place system into the Armed state. 3. Press Button 2 to stop panic and place system into the Disarmed state.
Page 8 - MS2004 Owner’s Manual 6. Enter the code again and hold for 10 seconds on the last press. • The siren will chirp 3 times. • The parking lights will flash 3 times. • The LED will flash a number of times equal to the new code. 7. Release the switch.
MS2004 Owner’s Manual - Page 9 Valet Mode Allows you to temporarily disable the security system when the car is being service or turned over to a parking attendant. To turn Valet Mode on or off: 1. Turn on the ignition. 2. Press and hold the override switch.
Dome Light Control For increased safety and convenience this optional feature will automatically turn on the dome light when you Disarm the system. With this feature installed, the dome light will turn on for 30 seconds when the system is disarmed (or unlocked in Valet Mode) using the Remote Transmitter.
Remote Car Starter When an optional Remote Car Starter is installed into your car, the Remote Transmitter can be used to remotely start and run your vehicle to warm-up the engine, as well as activate the heating / air conditioning system.
Page 12 - MS2004 Owner’s Manual Notes.
MS2004 Owner’s Manual - Page 13 Notes.
Page 14 - MS2004 Owner’s Manual Technical Data Specifications Main Unit Voltage: 12v, negative ground Current Consumption: <15mA Temperature Range: -40 o F to +257 o F Auxiliary Output Capability: 500mA Internal Relays: (1) 30A, (3) 15A Transmitter Current Consumption: <.
MS2004 Owner’s Manual - Page 15 1. Ungo Security Corporation of Gardena, California ("Ungo Security") warrants this Ungo system to be free from defects in materials and workmanship and to comply with Ungo Security’s applicable printed specifications.
Ungo Security Corporation A Clarion Company 661 West Redondo Beach Blvd. Gardena, CA 90247 800-Go-Clarion www.clarion-usa.com © Ungo Security Corporation, Gardena, CA 97-MS2004-10 Rev.
An important point after buying a device Clarion MS2004 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Clarion MS2004 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Clarion MS2004 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Clarion MS2004 you will learn all the available features of the product, as well as information on its operation. The information that you get Clarion MS2004 will certainly help you make a decision on the purchase.
If you already are a holder of Clarion MS2004, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Clarion MS2004.
However, one of the most important roles played by the user manual is to help in solving problems with Clarion MS2004. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Clarion MS2004 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
