Instruction/ maintenance manual of the product SCT81800S0 AEG
Go to page of 28
SCT81800S0 EN User manual.
CONTENTS 1. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. SAFETY INSTRUCTIONS In the interest of your safety and to en- sure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
WARNING! Any electrical component (p ower cord, plug, compressor) must be replaced by a certified service agent or qualified service per- sonnel to avoid hazard . 1. Power cord must not be length- ened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance.
• The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is a c- cessible after the installation of the ap- pliance.
9 Alarm indicator 10 Child Lock function 11 Minute Minder function 12 DYNAMICAIR function 2.2 Switching on To switch on the appliance do these steps: 1. Connect the mains plug to the pow- er socket. 2. Press the appliance ON/OFF button if the display is off.
The Timer start to flash (min). At the end of the countdown the Minute Minder indicator flashes and an audib le alarm sounds: 1. Remove any drinks contained in the freezer compartment. 2. Press OK button to switch off the sound and terminate the function.
To switch on the function: 1. Press the Mode button until the cor- responding icon appears. The Holiday indicator flashes. The fridge temperature indicator shows the set temperature. 2. Press the OK button to confirm. The Holiday indicator is shown. To switch off the function: 1.
The maximum amount of food that can be frozen in 24 hours is specified on the rating plate , a label located on the in- side of the app liance. The freezing process lasts 24 hours: dur- ing this period do not add other food to be frozen.
3.8 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. 3.9 Positioning the sliding box The sliding box can be pla ced at differ- ent heights. Do make these adjustments proceed as follow: 1.
3.11 DynamicAir The refrigerator compartment is eq uip- ped with a device that allows for rapid cooling of foods and more uniform tem- perature in the compartment. This device activates by itself when nee- ded, for example for a quick tempera- ture recovering after door opening or when the ambient temperature is high.
• the maximum quantity of food which can be frozen in 24 hrs. is shown on the rating plate; • the free zing process takes 24 hour s. No further food to be frozen should be added during this period.
After cleaning, reconnect the equip ment to the mains supply. 5.2 Replacing the carbon air filter To get the best performance the carb on air filter should be changed once every year. New active air filters can be purchased from your local dealer. Refer to "Installation of the carbon air fil- ter" for the instructions.
Problem Possible cause Solution The appliance is noisy The appliance is not sup- ported properly Check if the applianc e stands stable (all the four feet should be on the floor) The appliance does not operate. The lamp does not oper- ate. The appliance is switched off.
Problem Possible cause Solution Water flows on the rear plate of the re- frigerator. During the automatic de- frosting process, frost de- frosts on the rear plate. This is correct. Water flows into t he refrigerator. The water outlet is clog- ged. Clean the water outlet.
6.1 Replacing the lamp The appliance is equipped with a long- life LED interior light. Only service is allowed to replace the lighting device. Contact your Service Center. 6.2 Closing the door 1. Clean the door gaske ts. 2. If necessary, adjust the door.
3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp D is secure over the outer sheath. 5. Make sure the electricity supply volt- age is the same as that indicated on the appliance rating plate.
• Loosen the middle hinge . • Remove the lower door. • Loosen and remove the low er pin. On the opposite side: • Tighten the lower pin. • Install the lower door. • Tighten the middle hinge. • Install the spacer. • Install the upper door.
x x If necessary cut the adhesive sealing strip and apply it to the appliance as shown in figure. 1 2 Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture.
I I Attach the appliance to the niche w ith 4 screws. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of rig ht hinge, SX in opposite case. E E B D C Attach the covers (C, D) to the lugs and the hinge holes.
G H Connect the appliance laterally to the kitchen furniture sidewall: 1. Loosen the screws of the part (G) and move the part (G) till the furni- ture sidewall. 2. Tighten the screws of the part (G) again. 3. Attach the part (H) to the part (G). Disconnect the part s (Ha), (Hb), (Hc) and (Hd).
Ha Hc Push the pa rt (Hc) on the part (H a). Ha Hb 8 mm Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes.
Hb Place the small square on the guide again and fix it with the screws sup- plied. Align the kitchen furniture door and the appliance door by adjusting the part (Hb). Hb Hd Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened.
CLICK! CLICK! SSSRRR! SSSRRR! BRRR! BRRR! HISSS! HISSS! BLUBB! BLUBB! CRACK! CRACK! 24 www.aeg.com.
9. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Rising Time 25 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.
26 www.aeg.com.
ENGLISH 27.
www.aeg.com/shop 222358291-A-052013.
An important point after buying a device AEG SCT81800S0 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought AEG SCT81800S0 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data AEG SCT81800S0 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, AEG SCT81800S0 you will learn all the available features of the product, as well as information on its operation. The information that you get AEG SCT81800S0 will certainly help you make a decision on the purchase.
If you already are a holder of AEG SCT81800S0, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime AEG SCT81800S0.
However, one of the most important roles played by the user manual is to help in solving problems with AEG SCT81800S0. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device AEG SCT81800S0 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
