Instruction/ maintenance manual of the product SCN71800S1 AEG
Go to page of 28
SCN71800S1 EN User manual.
CONTENTS 1. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. SAFETY INSTRUCTIONS In the interest of your safety and to en- sure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
WARNING! Any electrical component (p ower cord, plug, compressor) must be replaced by a certified service agent or qualified service per- sonnel to avoid hazard . 1. Power cord must not be length- ened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance.
• The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is a c- cessible after the installation of the ap- pliance.
9 Alarm indicator 10 Child Lock function 11 Minute Minder function 2.2 Switching on To switch on the appliance do these steps: 1. Connect the mains plug to the pow- er socket. 2. Press the appliance ON/OFF button if the display is off. 3. The alarm buzzer could operate af - ter few seconds.
1. Remove any drinks contained in the freezer compartment. 2. Press OK button to switch off the sound and terminate the function. It is possible to deactivate the function at any time during th e countdown: 1. Press the Mode button until the Mi- nute Minder indicator flashes.
The fridge temperature indicator shows the set temperature. 2. Press the OK button to confirm. The Holiday indicator is shown. To switch off the function: 1. Press the Mode button until the Hol- iday indicator flashes. 2. Press the OK button to confirm.
In the event of accidental de- frosting, for example due to a power failure, if the power has been off for longer that the value shown in the technical character- istics chart under "rising time", the defrosted food must be con- sumed quickly or cooked imme- diately and then re-frozen (after cooling).
3.9 Positioning the sliding box The sliding box can be pla ced at differ- ent heights. Do make these adjustments proceed as follow: 1. lift the shelf with the sliding box up - wards and out of the holders in the door 2. remove the retaining bracket out of the guide under the shelf 3.
zen and to make it possible subse- quently to thaw only the quantity r e- quired; • wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; • do not allow fre.
• leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask som e- body to check it once in a while to pre- vent the food inside from spoiling in case of a power failure.
Problem Possible cause Solution The appliance has no power. There is no volt- age in the mains socket. Connect a different electri- cal appliance to the mains socket. Contact a qualified electri- cian. The lamp does not work. The lamp is in stand-by. Close and open the door.
Problem Possible cause Solution The door is not closed correctly. Refer to "Closing the door". The product temperature is too high. Let the product tempera- ture decrease to room temperature before stor- age. Many products are stored at the same time.
7. INSTALLATION WARNING! Read the "Safety Information" carefully for your safety and cor- rect operation of the appliance before installing the appliance.
13 amp ASTA approved (BS 136 2) fuse must be used. WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) ha zard. En sure that it is disposed of safely. 7.3 Door reversibility The door of the appliance opens to the right. To open the door to the left, do these steps before you install the a ppli- ance.
7.4 Ventilation requirements 5 cm min. 200 cm 2 min. 200 cm 2 The airflow behind the appliance must be sufficient. 7.5 Installing the appliance CAUTION! Make sure that the mains cable can move freely. Do these steps. x x If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure.
1 2 Install the applian ce in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the opposite side of the hinge.
Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hing e, SX in op- posite case. B E E D C Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge.
Disconnect the parts (Ha), (Hb), (Hc) and (Hd). ca. 50 mm ca. 50 mm 21 mm 90° 90° 21 mm Install the part (H a) on the inner sid e of the kitchen furniture.
Ha Hb 8 mm Open the appliance door and the kitch- en furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Ha K 8 mm Remove the brackets and mark a dis- tance of 8 mm from the outer edge of the door where the na il must be fitted (K).
Hb Hd Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened . • The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. 8. NOISES There are some sounds during normal running (compressor, refrigerant circula- tion).
BRRR! BRRR! HISSS! HISSS! BLUBB! BLUBB! CRACK! CRACK! 9. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 560 mm Rising Time 25 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.
10. ENVIRONMENT CONCERNS Recycle the materials with th e symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the sym bol with the household waste.
ENGLISH 25.
26 www.aeg.com.
ENGLISH 27.
www.aeg.com/shop 222358251-A-020213.
An important point after buying a device AEG SCN71800S1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought AEG SCN71800S1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data AEG SCN71800S1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, AEG SCN71800S1 you will learn all the available features of the product, as well as information on its operation. The information that you get AEG SCN71800S1 will certainly help you make a decision on the purchase.
If you already are a holder of AEG SCN71800S1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime AEG SCN71800S1.
However, one of the most important roles played by the user manual is to help in solving problems with AEG SCN71800S1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device AEG SCN71800S1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
