Instruction/ maintenance manual of the product SCN71800S0 AEG
Go to page of 32
SCN71800S0 EN FRIDGE-FREEZER USER MANUAL.
FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
CONTENTS 4 Safety information 6 Control panel 11 First use 11 Daily use 13 Helpful hints and tips 15 Care and cleaning 16 What to do if… 18 Technical data 18 Installation 26 Noises 28 Environmental .
SAFETY INFORMATIO N In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
– thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any wa y.
• Regularly examine the drain in the refrigerator for defrosted water. If necessary, clean the drain. If the drain is blocked, water will collect in the bottom of the appliance. Installati on For electrical connection carefully follow the instructions given in specific paragraphs.
3 Fridge Temperature warmer button 4 Mode button 5 OK button 6 Freezer Temperatur e colder button 7 Freezer Temperature warmer button 8 Display It is possible to change predefined sound of buttons to a loudly one by press ing together Mode button and Temperature colder button fo r some seconds.
1. Press the appliance ON/OFF button for 5 seconds . 2. The display switches off. 3. To disconnect the appliance from the power disconnect the mains plug from the pow - er socket. Switching off the fridge To switch off the fridge: 1. Press the Mode button until the corresponding icon appears.
2. Press the Timer regulator button to change the Timer set value from 1 to 90 minutes. 3. Press the OK button to confirm. The Minute Minder indicator is shown. The Timer start to flash (min). At the end of the countdown the Minute Minder indicator flashes and an audible alarm sound s: 1.
• flashing Alarm light • acoustic buzzer When normal conditions are restored (door closed), the alarm will stop. During the alarm, the buzzer can be switched off by pressing alarm button.
1. Press the Mode button until the corresponding icon appears. The FROSTMATIC indicator flashes. 2. Press the OK button to confirm. The FROSTMATIC indicator is shown. This function stops automatically after 52 hours. To switch off the function before its automatic end: 1.
Storage of frozen food When first starting-up or after a period out of use, before putting the products in the com - partment let the appliance run at least 2 hours on the higher settings. If large quantities of food are to be stor ed, remove all drawers and baskets from appliance and place food on cooling shelves to obtain the best performance.
Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be posi - tioned as desired. For better use of space, the front half-shelves can lie over the rear ones. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at dif - ferent heights.
warmer settings to allow automatic defrosting and so a saving in electricity consump - tion. Hints for fresh food refrigeration To obtain the best performance: • do not store warm food or evaporatin.
• be sure that frozen foodstuffs are transferred from the foods tore to the freezer in the shortest possible time; • not open the door frequently or leav e it open longer than absolutely necessary. • Once defrosted, food deteriorates rapidly and cannot be refrozen.
The absence of frost is due to the continuous circulation of cold air inside the compart - ment, driven by an automatically controlled fan. Periods of non-operation When the appliance is not in use fo.
Problem Possible cause Solution The room temperature is too high. Decrease t he room temper ature. The compre ssor doe s not start immediately after pressing the FROST MATIC or COOLMATIC button, or after changing the tem - perature. This is normal, no error has oc - curred.
Replacing the lamp CAUTION! Disconnect the plug from the mains socket. 1. Press on the rear hook and at the same time slide the cover in the direction of the arrow. 2. Replace the lamp with one of the same power and specifical ly designed for household appliances.
Positioning Install this appliance at a location where the ambient temperature correspo n ds to the cli - mate class indicated on the rating plate of the appliance: Climate class Ambient temperature S.
2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or col - oured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp 4 is secure over the outer sheath.
• Loosen and remove the lower pin. On the opposite side: • Tighten the lower pin. • Install the lower door. • Tighten the middle hinge. • Install the spacer. • Install the upper door. • Tighten the upper pin. Ventilation requirements 6 cm min.
1 2 Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the opposite side of the hinge.
Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. E E B D C Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge.
Disconnect the parts (Ha), (Hb), (Hc) and (Hd). ca. 50 mm ca. 50 mm 21 mm 90° 90° 21 mm Install the part (Ha) on the inner side of the kitchen furniture.
Ha Hb 8 mm Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appli - ance door and the furni - ture door and mark the holes. Ha K 8 mm Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K).
Hb Hd Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened. • The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. NOISES There are some sounds during normal running (compressor, refriger ant circulation).
BRRR! BRRR! BLUBB! BLUBB! HISSS! HISSS! SSSRRR! SSSRRR! Noises 27.
CRACK! CRACK! ENVIRONMENTAL CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
29.
30.
31.
www.aeg.com/shop 222344536-A-272011.
An important point after buying a device AEG SCN71800S0 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought AEG SCN71800S0 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data AEG SCN71800S0 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, AEG SCN71800S0 you will learn all the available features of the product, as well as information on its operation. The information that you get AEG SCN71800S0 will certainly help you make a decision on the purchase.
If you already are a holder of AEG SCN71800S0, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime AEG SCN71800S0.
However, one of the most important roles played by the user manual is to help in solving problems with AEG SCN71800S0. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device AEG SCN71800S0 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
