Instruction/ maintenance manual of the product FW852 CDA
Go to page of 24
Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer .
2 Important The manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that we reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance.
3 This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical safety (L VD) and Electromagnetic interference compatibility (EMC). Parts intended to come into contact with food conform to EEC/89/109 .
4 Important Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance. This is a household appliance, which is produced in accordance with the national standard. It is intended for food storage only , not for storage of blood, medicine and biological products.
5 Before First Use Y ou must allow the fridge to settle for at least twenty four hours prior to switching the power on. It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly drying the interior .
6 Use Fridge • Never put liquids in the refrigerator uncovered. • Never put hot foods in the refrigerator . W arm food should be allowed to cool to room temperature before being put into the refrigerator .
7 Freezer • The freezer compartments are designed to store only frozen food. • Never put hot or warm foods in the freezer , allow them to cool fully before putting them into the freezer . • Follow the instructions on the food packaging for storage of frozen food.
8 S torage The fridge section is for short term food storage. Although the temperature can be maintained between 0-10˚C, extended periods of food storage is not recommended. As the cold air circulates within the fridge, the temperature can vary between the dierent sections.
9 Control P anel A. R efrigerator Button This button is used to adjust the fridge temperature between 2°C and 10°C in 1°C increments. T o change the temperature setting, press this button once so the display shows the set temperature and flashes.
10 C. Freezer T emperature Display In normal running this shows the actual temperature in the freezer compartment. If the temperature in the freezer is higher than 0°C this will flash, otherwise it will be static. See below for how this display is used in setting the freezer temperature.
11 After changing the temperature setting, the time taken to achieve the new temperature will depend on how big the change is from the previous setting. Switching On and O When the fridge freezer is connected to a power supply it will automatically switch on.
12 Care and Cleaning Always disconnect the appliance from the power supply before any cleaning or maintenance. The fridge and freezer sections should be cleaned using a solution of bicarbonate of soda and lukewarm water . Do not use abrasive products or detergents.
13 Defrosting the Fridge The fridge is self-defrosting. Any water created will run out of the fridge through the channel at the back of the fridge. It is important to keep the channel clear at all times using the cleaning tool supplied.
14 the freezer compartment. • The freezer should be cleaned using a solution of bicarbonate of soda and lukewarm water . Do not use abrasive products or detergents. After washing, rinse and dry thoroughly . • Clean the drawers separately by hand with a mild solution of washing up liquid and water .
15 T roubleshooting If you have any problems with your appliance, you should check the troubleshooting prior to calling CD A Customer Care to prevent unnecessary service calls and potential cost. If the appliance is not working • Check there is power to the appliance.
16 There is water in the lower part of the refrigerator compartment • The drain hole in the channel at the back of the compartment is clear . Ice has formed on the back wall of the fridge • It is normal for some ice droplets to form on the back wall of the fridge.
17 Installation and V entilation This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places. • T o ensure the appliance is level, you should use the height adjustable feet at the front of the appliance.
18 V entilation The main consideration when installing any refrigeration unit into a fitted kitchen is ventilation. The heat removed from the cooling compartment needs to be dissipated into the atmosphere. Incorrect ventilation can lead to premature compressor failure, ex cessive power consumption and total system failure.
19 The open channel at the rear is clearly shown. For the correct operation of the appliance it is important that the top of the housing unit is not blocked o . A channel depth of 40-50mm is normal with most units. A hole is shown in the base shelf of the unit; this allows air to be drawn over the compressor & heat ex change.
20 Mounting the Fascia Doors • Position the appliance within the unit. Ensure that there is a gap of 3 to 4mm between the non-hinged side and the cabinet wall.
21 R eversing the Doors W e recommend you seek the help of another individual to support the doors whilst performing this operation. 1. Carefully prise o the cover cap for the top hinge and unscrew the screws fixing the top hinge to the appliance, you should support the upper door whilst doing this.
22 Ensuring the door seals correctly: It is normal for the seal to be compressed after the door has been reversed. With the door closed, use a hair dryer to expand the seal and fill the gap between the door and the body of the appliance. T ake care not to use the hair dryer too close to the appliance, which could damage the seal.
23 3. R eplace fuse cover . Important: Do not use the appliance without the fuse cover in position. How to connect an alternative plug If the fitted plug is not suitable for your socket outlet, then it should be cut o and disposed of safely to avoid possible shock hazard.
Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer .care@cda.eu W : www. cda.eu www .cda.eu Please contact our Customer Care Department for Service on the details below Customer Care Department The Group L td.
An important point after buying a device CDA FW852 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought CDA FW852 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data CDA FW852 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, CDA FW852 you will learn all the available features of the product, as well as information on its operation. The information that you get CDA FW852 will certainly help you make a decision on the purchase.
If you already are a holder of CDA FW852, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime CDA FW852.
However, one of the most important roles played by the user manual is to help in solving problems with CDA FW852. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device CDA FW852 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
