Instruction/ maintenance manual of the product EC-T220 Cateye
Go to page of 44
® Cateye Treadmill Instruction Manual MODEL EC-T220 EC-T22O TREADMILL.
2 H OW TO USE THIS MANUAL After first reading the "Start Guide," assemble the machine and give the Model EC-T220 Treadmill type Cat eye Fitness a try. Once you've become accustomed to the machine, read the "Operation Guide" and experi- ment with the EC-T220's wealth of functions.
3 Always unplug from the electrical outlet immedi- ately after using and before cleaning. Do not leave plugged in. Turn all controls to the off position before removing the plug from the outlet. Remove the plug without pulling the cord. Do not operate where aerosol (spray) products are being used or where oxygen is being adminis- tered.
4 P AR T NAMES Main body Drink holder Control unit Handle Handle mast Motor cover Breaker Power cable Power switch Running belt Side rails These rails may be stood on when setting a training program or for emergencies.
5 EC-T220 123 123 INCLINE INCLINE HILL HILL INTER INTER V AL AL TIME TIME SPEED SPEED DIST DIST ANCE ANCE HR control HILL INTERV AL QUICK MODE ST OP EMERGENCY ST OP INCLINE SPEED ST ART 2 3 7 9 0 0 q .
STARTING UP S TA R T G UIDE 1 Starting with assembly ............................................................. 7 2 Preparation and warnings before getting on the treadmill .... 11 3 Putting on the chest-belt heart rate sensor .....................
7 1 7 2 -2 2 -2 2 -2 2 -1 2 -1 4 4 E C -T220 2 -1 6 6 S T A R T HR control H IL L INTERVAL Q U IC K M O D E S TO P EMERGENCY STOP I N C L I N E S P E E D IN C L IN E I N T E R V A L TIM E 12 31 2 3 H .
8 EC-T220 1 Remove the motor cover. • The motor cover must be removed for assembly. 2 Attach the handle masts and handle. • Insert the handle into the sides of the handle masts. Fix in place by screwing in the 2 bolts (B) from above. Caution: • Be sure which handle mast is the left one and which is the right one before inserting the handle.
9 4 Attach the control unit base to the handle masts. • Position the control unit cross to the handle masts, and then pre- pare to pass the cords through the handle mast inside. Caution: Be careful that the control unit does not fall down. • Remove the wire (lower side) which is wrapped around the handle mast.
10 INTERV AL QUICK MODE EMERGENCY STOP SPEED ST ART INTERV AL QUICK MODE EMERGENCY STOP SPEED ST ART 7 Adjust the running belt. Caution: • Do not operate the buttons while standing on the belt. • When adjusting the belt, take care not to get your hands trapped or pinched.
11 H I L L E M E R G E N C Y S T O P IN C L IN E S P E E D 2 P REP ARA TION AND W ARNINGS BEFORE GETTING ON THE TREADMILL W arning Be sure to securely stop the running belt by pressing either the EMERGENCY button or STOP button before you step up on the EC-T220.
12 MSC Wireless Heart Rate Sensor TOP MSC Wireless Heart Rate Sensor TOP 3 P UTTING ON THE CHEST - BEL T HEAR T RA TE SENSOR Your heart rate can be measured by the chest-belt heart rate sensor. The EC-T220 treadmill receives and calculates the number of heartbeats which are transmit- ted from the wireless chest-belt.
13 n t r ol H I L L INTERV AL QUI EMERGENCY ST OP INCLINE SPEED INTERV AL QUICK MODE EMERGENCY ST OP SPEED ST ART 2 HILL IN TE R V A L M O D E E M E R G E N C Y ST OP INCLINE SPEED HIL L 1 3 2 4 T R YING OUT THE TREADMILL FOR THE FIRST TIME 1 Put on the chest-belt heart rate sensor and turn on the power.
14 INTERV AL QUICK MODE EMERGENCY ST OP SPEED ST ART INTERV AL QUICK MODE EMERGENCY ST OP SPEED ST ART EC-T220 INCLINE HILL INTERV AL TIME 123 123 SPEED DIST ANCE HR control H I L L I NTERV AL QUICK MODE STOP EMERGENCY STOP INCLINE SPEED ST ART 1 2 4 5 4 Start your exercise.
15 HR control H I L L STOP EMERGENCY ST OP INCLINE INTERV AL QUICK MODE EMERGENCY ST OP SPEED ST ART 5 You can select a display of either incline or speed by pressing the MODE button. • You can switch between the incline and speed displays by pressing the MODE button.
16 5 T HE 4 KINDS OF PROGRAMS HR control training (Training at a set pulse rate) • You set a target pulse rate at which you want to exercise and the Model EC-T220 automatically adjusts the incline to maintain your pulse rate close to the desired level.
17 Hill profile training (Casual mountain climbing) • The incline changes to simulate the effects of climbing up and down mountains. The changing patterns of the incline are shown on the screen. • The following three types of mountain profiles are programmed.
18 Training mode HR control H I L L I NTERVAL QUICK MODE P EMERGENCY STOP INCLINE SPEED HR control H I L L STOP EMERGENCY ST OP INCLINE 6 U SING THE EC-T220 WITHOUT A DA T A CARD The blue card you used for your first session serves to input the type and conditions of training.
19 INTERV AL QUICK MODE EMERGENCY ST OP SPEED ST ART n t r ol H I L L INTERV AL QUI EMERGENCY ST OP INCLINE SPEED HR control H I L L STOP EMERGENCY ST OP INCLINE HR control H I L L STOP EMERGENCY ST OP INCLINE 4 Start your exercise. • After inputting the training condition, get on the running belt and press the START button.
O PERA TION G UIDE 1 Training goals ......................................................................... 22 2 Training program characteristics ......................................... 24 3 HR control training ....................................
.
22 Exercise time for each session • A minimum of 30 minutes of exercise is most effective for each session of exercise. A 5 minute warm up period, 20 minutes of exercise time, with a 5 minute cool-down period, is suggested for standard exercise.
23 Maximum Heart Rate The heart rate increases according to the intensity of exercise, but there is a limit. The highest heart rate that a person can sustain is called the "maxi- mum heart rate".
24 HR control training • This training program is for exercising while maintaining a set pulse rate. The incline of the running belt will change automatically so that the set pulse rate is maintained. The speed can be adjusted however you like. If the chest-belt heart rate sensor cannot pick up your pulse rate, this program will not work.
25 Interval training • This program is intended for serious exercisers with training experience. This training automatically changes the speed between "exercise (maxi- mum speed)" and "rest (minimum speed)." The incline does not change, so you can adjust the incline to suit your needs.
26 Select the HR control training program. • Put the chest-belt heart rate sensor around your chest. Press the HR control button to select the HR control training program. Caution: If you do not put the chest-belt heart rate sensor around your chest, the HR control training cannot be performed.
27 Finish your training. • The buzzer will sound at the specified time. However you can con- tinue training if you wish. • Pressing the STOP button will end your training and begin cool- down.
28 Input training conditions. • Input the exercise pattern and exercise time in order on the LCD screen. If nothing is input, the initial values as shown below are displayed.
29 5 6 7 Finishing training HR control HILL STOP EMERGENCY STOP INCLINE HR control HILL STOP EMERGENCY STOP INCLINE Ending program INTERV AL QUICK MODE EMERGENCY STOP SPEED ST ART Increase or decrease of speed HR control HILL STOP EMERGENCY STOP INCLINE Increase or decrease of incline End the program.
30 Input training conditions. • Input the exercise pattern and exercise time in order on the LCD screen. If nothing is input, the initial values as shown below are dis- played.
31 Finishing training HR control H I L L STOP EMERGENCY ST OP INCLINE HR control H I L L STOP EMERGENCY ST OP INCLINE Ending program 5 6 7 INTERV AL QUICK MODE EMERGENCY ST OP SPEED ST ART Increase or decrease of speed HR control H I L L STOP EMERGENCY ST OP INCLINE Increase or decrease of incline End the program.
32 Select the Quick start program and start walking. • Put the chest-belt heart rate sensor around your chest. Press the QUICK button to select the quick start program. • The buzzer will sound and the belt will start moving. • The screen will change to the quick start screen.
33 Finish your training. • Press the STOP button when you want to finish. Your training will be stopped, and cool-down will begin. The speed and incline will be reduced to the minimums. Reference: • Alarm (buzzer) function is not available for quick start.
34 INTVL INTVL HR HR CONTR CONTR OL OL ABCDEFGHI 9 8 7 6 5 4 3 2 1 0 INTVL INTVL HR HR CONTR CONTR OL OL ABCDEFGHI 9 8 7 6 5 4 3 2 1 0 INTVL INTVL HR HR CONTR CONTR OL OL ABCDEFGHI 9 8 7 6 5 4 3 2 1 0 Caution: • One data card is necessary for each set of training condi- tions.
35 Indicate your target pulse rate. (For HR control training only) Specify the training target in columns G, H and I. G is for the first digit of the value (hundreds' column), H for the sec- ond digit (tens' column), and I for the third digit (ones' column).
R EFERENCE G UIDE 1 Maintenance of the chest-belt heart rate sensor ................ 38 2 Other useful functions ........................................................... 39 3 Troubleshooting .........................................................
.
38 M AINTENANCE OF THE CHEST - BEL T HEAR T RA TE SENSOR 1 Replacing the battery Battery life: approx. 2 years (if used for 1 hour per day) * The battery life shown in this manual is not definitive and it var- ies depending on the use environment.
39 O N 1 2 3 4 D I P O N 1 2 3 4 D I P O N 1 2 3 4 D IP O N 1 2 3 4 D IP Checking the total distances The total distances which can be used as a guide for when to change the running belt can be checked. • Press and hold the SPEED + button and the INCLINE + but- ton together for 3 seconds to change to the total distance check display.
40 T ROUBLESHOOTING Troubleshooting In the following cases, the machine is not broken. Be sure to check the following before asking for the machine to be serviced. Trouble Check items Action Refer to page 10. Adjust the belt so the bal- ance between the left and right sides is im- proved.
41 H ANDLING W ARNINGS Handling warnings Please observe the following to ensure that you will have many years of good use from your EC-T220 treadmill. Caution • Do not disassemble the control unit or main body. If there is a problem, contact your dealer where the unit was purchased.
42 About the repair service warranty • If trouble with this EC-T220 treadmill due to material of manufacturing defect should occur, under normal usage conditions, within one year from the date of pur- chase, Cat Eye Co., Ltd. will repair or replace the product/part, subject to the con- tents of the included warranty card.
43 Item Specification Power source H o m e A C Power (For commercial use, dedicated circut only) 115 volts 20 amps (for the 100V-120V area) 230 volta 10 amps (for the 220V-240V area) Power consumption Max.
® 2-8-25, Kuwazu, Higashi Sumiyoshi-ku, OSAKA, 546-0041 JAPAN PHONE: 81-6-6719-7781 FAX: 81-6-6719-2362 CO . , L TD. 066660011 (E).
An important point after buying a device Cateye EC-T220 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Cateye EC-T220 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Cateye EC-T220 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Cateye EC-T220 you will learn all the available features of the product, as well as information on its operation. The information that you get Cateye EC-T220 will certainly help you make a decision on the purchase.
If you already are a holder of Cateye EC-T220, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Cateye EC-T220.
However, one of the most important roles played by the user manual is to help in solving problems with Cateye EC-T220. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Cateye EC-T220 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
