Instruction/ maintenance manual of the product DK 1160 AEG
Go to page of 18
DK 1 160 DK 1 190 Dunstabzugshaube Afzuigkap Hotte aspirante Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice et d’utilisation et d’installation Operating and .
64 Contents Safety warnings 6 4 for user 6 4 for kitchen unit installer 6 4 Introduction 6 6 Extractor version 6 6 Filter V ersion 6 7 Hood Operation 6 8 Maintenance and care 7 0 Metal grease filter 7.
65 Safety warnings for user • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep frying pan on the cooker top/ cooker under careful control.
66 • When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approximately the same as the outlet hole.
67 Introduction Extractor version • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one activated carbon filter (special accessory). • Y ou will need original AEG carbon filter for this function (see Special Accessories).
68 Filter V ersion • The air is filtered through an activated charcoal filter and returned to the kitchen through the top grill of the outlet pipe. • Y ou will need an original AEG KF20 activated carbon filter for the filtering function. (See Special Accessories).
69 Hood Operation • The hood is fitted with one motor having several speed. T urn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared.
70 Maintenance and care • The hood must always be disconnected from the mains power supply before beginning any maintenance work. Metal grease filter • The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the external evacuation or internal recycling function.
71 Carbon filter • The carbon filter should only be used if you want to use the hood in its filtering function. • T o do this you will need an original AEG activated carbon filter (see special accessories). • This filter cannot be cleaned or reused.
72 W arning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions.
73 Cleaning • W arning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor ’ s protective grid. • W ash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders.
74 Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser , which must be verified by purchase invoice or similar documentation.
75 Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home.They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances.
76 T echnic Details Models: DK 1 160 DK 1 1 90 Dimensions (in cm): Height 87,5-1 1 1,6 87,5-1 1 1,6 Width 59 ,8 89 ,8 Depht 51,5 51,5 Maximum absorbed power: 250 W 250 W Motor absorption: 170 W 170 W .
77 Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply , check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access.
78 W all unit mounting - Fig. 7 • Put the template onto the wall (1) and drill two Ø 12mm holes (2) . • Fit two hooks (3) on the drilled holes. • Hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (5) .
79 Fig. 7 Ø 120 mm.
AEG Hausger ä te GmbH Postfach 1036 D-90327 Nürnberg http:/ /www .aeg.hausgeraete.de © Copyright by AEG LI1USB Ed.03/02.
An important point after buying a device AEG DK 1160 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought AEG DK 1160 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data AEG DK 1160 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, AEG DK 1160 you will learn all the available features of the product, as well as information on its operation. The information that you get AEG DK 1160 will certainly help you make a decision on the purchase.
If you already are a holder of AEG DK 1160, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime AEG DK 1160.
However, one of the most important roles played by the user manual is to help in solving problems with AEG DK 1160. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device AEG DK 1160 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
