Instruction/ maintenance manual of the product 6643050 Casablanca Fan Company
Go to page of 16
1 INTRODUCTION 1 MOUNTING RECOMMENDA TIONS 2 F AN INST ALLA TION - GETTING ST ARTED 3 CONTROL FEA TURES: 4-SPEED 7 INTELI•TOUCH 9 TROUBLE SHOOTING 10 ADV AN•T OUCH 13 TROUBLE SHOOTING 16 CIRCUIT B.
2 MOUNTING RECOMMEND A TIONS SLOPED CEILING INST ALLA TIONS Before mounting your Casablanca fan, read the following helpful recommendations. e location of the fan, air circulation, and fan size are all important factors to consider before installation.
3 Using Existing Ceiling F ixture Outlet Box After turning the power OFF at its source (either the circuit breaker or fuse box), lower the old fi xture and disco nnect the wiring. Check the ceiling fi xture outlet box to be sure it is marked “ Approved for Ceiling F an Mounting.
4 Prepar e for f an installation as follo ws: 3a. Route the wir es from th e motor thr ough the P erma • Lock™ downr od and ball assembly . 3b . Usin g the pr ovid ed allen wrench, loosen th e set screw several turn s to allow installati on of th e downr od.
5 Step 5. T o han g the f an body in th e canopy , hold the f an body fi rmly and insert th e ball into th e canopy open- ing. Ch eck that no wir es were pin ched . Rotate the f an body un til the slot in th e nylon ball fi ts into th e pin opposite the canopy openin g.
6 PROCEED TO Y OUR F AN’S CONTROL FEA TURE SECTION FOR INST ALLA TION/OPERA TING INSTRUCTIONS: 4-SPEED - P A GE 7 | INTELI•TOUCH2 - P AGE 9 Install th e assembled blade an d blade h older to th e motor . Hand tigh ten securely . Repeat for each assembly .
7 Pull-chain switches on th e fan con trol th e fan an d lights . Usin g the f an contr ol pull-chain switch: Fan off at start. First pull: fan ON, Hi gh speed Second pull: Medium speed Third pull: Medium Low speed Fourth pull: Low speed Fifth pull: Fan OFF Usin g the opti onal li ght pull-chain switch: Li ght off at start.
8 R • The f an may be turn ed ON and OFF by the W-81 wall con trol. • The ligh ts may be turn ed ON and OFF by the W-81 an d the in tensity adjusted from low to hi gh. • The f an must be suppli ed with two ind epend ent 120V A C supply wires . • Set the F AN pull chain switch to the HI GH speed setting.
9 R R The wall con trol in stalls in the sam e mann er as an ordinary li ght switch, usin g an existin g juncti on box an d wiring. This contr oller is desi gned to si gnal th e fan micr ocomputer as well as perform n ormal switchin g operati ons . For this reason the followin g precauti ons m ust be observed: 1.
10 Inteli•T ouch ™ R R Progr ammed into every In teli-T ou ch Series fan is an A utomati c Demon strati on Program. I t can be used to fully dem onstrate an d test the oper ation o f the fan. T o enter the demonstration program: 1. T urn PO WER off f or at least three secon ds.
11 The Li ght-Min der pr ogram autom atically turns OFF th e fan m ounted li ghts after two hours . T o enter the Light-Minder Pro gram: 1. T urn th e PO WER OFF for at least three secon ds. 2. T urn the 3. Immedi ately operate th e buttons in th e followin g sequence: + + + + + + 4.
12 Inteli•T ouch ™ Before Requesting Service: Please follo w this troubleshooting guide be- fore contacting your dealer for assistance. Caring for Finishes : For cleanin g, a soft brush or lint-fr ee cloth should be used to pr event scr atching the fi nish.
13 AD V AN•T OUCH W-62 BRA CKET/HOLSTER REMO V AL Step 1. Remove th e two 6-32 x 5/16” screws holdin g the br acket to the h olster . Save screws for later . AD V AN•T OUCH CONTROL BRACKET INST ALLA TION Standard Light Switch Step A. Remove th e two screws h olding th e switch cover plate .
14 Install 4 “ AAA ” alkaline batteries in th e space provi ded. Please observe proper polarity placem ent. Replace Battery Door . Open Battery Door by pressin g down on the in sert tab pro- vide d. AD V AN•T OUCH OPERA TION Fan Operation The A dvan•T ou ch fan is con trolled by the r emote con trol.
15 1 ON ECE 23 45 A4 A4 A4 A4 + + + + –– AD V AN•T OUCH CHANGING FREQUENCY SETTING Y ou will ha ve to chang e the dip switch settings in the remote if y ou ar e using more than one fan in the same area and want to contr ol them separately . Step 1.
16 TROUBLESHOO TING Before Requesting Service: Please follow this tr oubleshooting guide before contacting your dealer for assistance. Caring for Finishes : For cleanin g, a soft brush or lint-fr ee cloth should be used to pr event scr atching the fi nish.
An important point after buying a device Casablanca Fan Company 6643050 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Casablanca Fan Company 6643050 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Casablanca Fan Company 6643050 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Casablanca Fan Company 6643050 you will learn all the available features of the product, as well as information on its operation. The information that you get Casablanca Fan Company 6643050 will certainly help you make a decision on the purchase.
If you already are a holder of Casablanca Fan Company 6643050, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Casablanca Fan Company 6643050.
However, one of the most important roles played by the user manual is to help in solving problems with Casablanca Fan Company 6643050. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Casablanca Fan Company 6643050 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
