Instruction/ maintenance manual of the product 54007 Casablanca Fan Company
Go to page of 17
www .CasablancaF anC o.com 1.888.227.2178 Congratulations on purchasing your new Casablanca® ceiling fan! It will provide comfort and per formance in y our home or ofce for man y years. This installation and operation manual contains complete instructions for installing and operating your fan.
www .CasablancaF anC o.com 1.888.227.2178 M6004-01 • 08/13/12 • © Casablanca F an Company www .CasablancaF anC o.com 1.888.227.2178 1.888.227.2178 What t o Expec t with Y our Installation Know your wiring If you are unfamiliar with wiring, use a qualied electrician.
www .CasablancaF anC o.com 1.888.227.2178 T ools Needed Ladder Po wer Drill (optional) 9/64” Drill Bit (optional) Screwdrivers Pliers Wire Strippers If mounting to a support structure, you will also need these tools .
www .CasablancaF anC o.com 1.888.227.2178 If you ha ve an angled ceiling: 1. Y ou will need a longer downrod (sold separately) . 2. If your ceiling angle is greater than 34°, y ou will also need an Angled Mounting Kit (sold separately) .
1.888.227.2178 www .CasablancaF anC o.com C eiling Bracket Installa tion OFF Make sure all four (4) bumpers are still attached . F or angled ceilings, point opening toward peak.
www .CasablancaF anC o.com 1.888.227.2178 C eiling Bracket Installa tion (continued) Prepar ation D I S C A R D K E E P ! Remove the shipping blocks fr om the motor . Sav e the ve scre ws. The y will be needed for blade iron installation. 1.888.227.
1.888.227.2178 Downrod Slid e Slid e 1 2 3 4 5 6 7 8 9 10 Sold Separately Included Longer Downrod for angled ceilings or ceilings 10’ or higher Shorter Downrod for fans installed close to ceiling St.
KEEP! 8” 3/8” C U T & S T R I P (not to scale) Remove the pr e-installed setscrew so that the downrod can be inserted. Hand tighten the downrod (at least 4-5 full turns) until it stops. The wires can be cut, but leave at least 8” extending from the top of the downr od.
www .CasablancaF anC o.com 1.888.227.2178 9 M6004-01 • 08/13/12 • © Casablanca F an Company Downrod (c ontinued) Put the wires and do wnrod through the canopy . Let the canop y sit loosely on top of the fan. DO NO T PICK THE F AN UP BY THE CANOPY OR WIRES.
www .CasablancaF anC o.com 1.888.227.2178 Wiring F R O M F A N F R O M C E I L I N G B R A C K E T F R O M F A N Using an orange wire connector from the hardware bag , connect the 3 grounding wires (green, green/ yellow stripe , or bare copper) coming from the ceiling , downrod, and hanging bracket.
www .CasablancaF anC o.com 1.888.227.2178 11 M6004-01 • 08/13/12 • © Casablanca F an Company Canop y Lift the canopy into place so that the screw holes are aligned . Position the canop y so that, when lifted into place , the canopy ts into the hanging bracket as shown.
www .CasablancaF anC o.com 1.888.227.2178 M6004-01 • 08/13/12 • © Casablanca F an Company Blades Insert grommets found in the hardware bag into the holes in the blades, then secure each blade to a blade iron with screws found in the hardw are bag.
www .CasablancaF anC o.com 1.888.227.2178 S witch Housing F eed the wire plug through the center hole of the upper switch housing , then wrap keyhole slots around the screws and twist counterclockwise. Screw two (2) housing assembly screws from the hardware bag halfwa y into the motor housing .
www .CasablancaF anC o.com 1.888.227.2178 Connect the plugs from the upper and lower switch housings . Mak e sure to line up the colored markings on the connectors. Lift the lower switch housing up until the holes line up with the screw holes in the upper switch housing .
www .CasablancaF anC o.com 1.888.227.2178 Light Kit (c ontinued) C ONGRA TULA TIONS! Y OU’RE DONE! Insert three (3) switch housing screws found in the hardware bag . Install the CFL bulbs into the sockets. When necessary , replace with bulbs of same wattage.
www .CasablancaF anC o.com 1.888.227.2178 M6004-01 • 08/13/12 • © Casablanca F an Company 16 Maintenanc e & Cleaning The pull chain controls the fan: high, medium, low , extra low , and off . The light pull chain controls the power to the light xture: on and off .
www .CasablancaF anC o.com 1.888.227.2178 17 M6004-01 • 08/13/12 • © Casablanca F an Company T roubleshooting Exc essive wobbling • Tighten all of the blade and blade iron screws until they are snug . • T urn the power off , support the fan carefully , and check that the hanger ball is properly seated .
An important point after buying a device Casablanca Fan Company 54007 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Casablanca Fan Company 54007 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Casablanca Fan Company 54007 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Casablanca Fan Company 54007 you will learn all the available features of the product, as well as information on its operation. The information that you get Casablanca Fan Company 54007 will certainly help you make a decision on the purchase.
If you already are a holder of Casablanca Fan Company 54007, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Casablanca Fan Company 54007.
However, one of the most important roles played by the user manual is to help in solving problems with Casablanca Fan Company 54007. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Casablanca Fan Company 54007 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
